LSFS213ST (ASTCNA3) LG Refrigerator - Instructions

All Instructions for the LSFS213ST
76 - 90 of 91

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Replace the light switch for the refrigerator
1 of 2 people found this instruction helpful.
  • Karyn from DURHAM, NH
  • Really Easy
  • Less than 15 mins
Cover the putty knife with tape so you do not scratch the side wall where the switch is located. Slide the knife under the edge of the switch and push in a bit towards the switch and slightly twist to pop the switch out of its hole. Disconnect the wires from the switch and simply plug in the new switch. Push wiring back into the hole and careful push the switch into the hole until it snaps into place.
Was this helpful?
Thank you for voting!
Lower ice maker water feed froze and caused leak. Needed new water valve.
2 of 5 people found this instruction helpful.
  • Thomas from YORKTOWN, VA
  • Really Easy
  • 15 - 30 mins
  • Pliers, Screw drivers
Took pics of original install, removed old valve, water tubes & plugs. Installed new valve, reconnected electronic plugs, water tubes, turned water back on and all has been well since. Thank you for your timely delivery!
Was this helpful?
Thank you for voting!
cannot get water to the icemaker
1 of 2 people found this instruction helpful.
  • PAUL from AMARILLO, TX
  • Very Difficult
  • More than 2 hours
  • Nutdriver
i changed the filter and was able to get water to the white coil at the bottom of the dispenser (left door) but could never get water to the icemalker.i also replaced the pump at the bottom of the door as well as the green ebr699172 dispenser electrical board.still can not get water to the icemaker.any help will be greatly appreciated.< br />paul
Was this helpful?
Thank you for voting!
Valve assembly leaked
2 of 6 people found this instruction helpful.
  • Richard from TORRANCE, CA
  • Very Difficult
  • More than 2 hours
The assembly sent is different than what is on the unit. The connectors do not match. We called and it seems you don’t have the correct part. The only part we have found will only connect the ice maker or the water. It will be a shame if I have to buy a new refrigerator.
Was this helpful?
Thank you for voting!
Ice chute would not open.
18 of 54 people found this instruction helpful.
  • Steve from MUKWONAGO, WI
  • Easy
  • 30 - 60 mins
  • Screw drivers
Removed ice dispenser and display with small screwdriver from front of the fridge. Pried out the whole piece slowly. This exposed the motor that activates the chute. Plugged in the new motor before any removal to verify the motor was the problem. When it worked, removed old and installed new. 3 screws. Piece of cake.
Was this helpful?
Thank you for voting!
Refrigerator light had a short in it and would randomly work
1 of 3 people found this instruction helpful.
  • Tammy from HAGERSTOWN, MD
  • Very Easy
  • Less than 15 mins
  • Screw drivers
Unplugged the fridge. Used a screwdriver to loosen the switch. Easy to disconnect from fridge and just plugged the new switch in. Popped right back into the side of the fridge and worked perfectly.
Was this helpful?
Thank you for voting!
Unit kept beeping as if the freezer door was open
0 of 1 people found this instruction helpful.
  • Paul from San Jose, CA
  • Really Easy
  • Less than 15 mins
  • Pliers
I popped the old switch out of place and then disconnected the wire harness from the switch with a pair of needle nose pliers. I then inserted the harness into the new switch and popped the switch into place. Super easy and fast.
Was this helpful?
Thank you for voting!
light out
0 of 1 people found this instruction helpful.
  • Jack from Ellenton, FL
  • Easy
  • Less than 15 mins
  • Screw drivers
slid screw driver under edge of switch, easy.
Was this helpful?
Thank you for voting!
My dishwasher was leaking water
0 of 2 people found this instruction helpful.
  • rosalie from wayne, NJ
  • Really Easy
  • 15 - 30 mins
The repair went well. They actually had to replace the motor. This saved me a lot of money having it repaired in this manner. Very professional & pleasant.
Was this helpful?
Thank you for voting!
plastic tube leaking at connector
1 of 5 people found this instruction helpful.
  • GREG from STILLWATER, NJ
  • Really Easy
  • 15 - 30 mins
  • Pliers, Wrench (Adjustable)
Uncoupled the old connector, replaced with new connector and attached supply line. Repair easy with right part, prior to ordering the right part I had tried a compression fitting and it still leaked. U-tube and others demonstrating repair assured me I was on the right path.
Was this helpful?
Thank you for voting!
replace hand screw
2 of 11 people found this instruction helpful.
  • dorothy from SALISBURY, MD
  • Very Easy
  • Less than 15 mins
  • Screw drivers
unfortunately my fridge stopped working. I purchased another but wanted to try and repair the old one. when ew one arrived, the old one was supposed to be put in garage but instead was hauled away. Had delivery return next day but they had as already removed and lost the handle screw for the bottom freezer and the screw that holds handle in place. ordered the handle screw and picked up the nut. very simple to install the screw and put handle back on.
Was this helpful?
Thank you for voting!
Frost in the freezer. Icemaker frozen.
1 of 8 people found this instruction helpful.
  • Teresa from Miami, FL
  • Really Easy
  • More than 2 hours
I called LG and followed the instructions given over the phone. The instructions couldn't have been simpler. Disconnect the appliance for several hours and then connect again. I disconnected the appliance overnight, cleaned out the freezer, and reconnected it. Problem solved. Did not need to call a repairman and did not use the clips.
Was this helpful?
Thank you for voting!
Ice Maker quit working
  • Russell from Baytown, TX
  • Easy
  • Less than 15 mins
  • Screw drivers
Removed 4 Stainless steel screw holding mounting assembly containing ice maker and motor. Unplug large plug from refrigerator inside wall and removed assembly. Closed refrigerator and lay asembly on flat surface. Removed ice maker plug from wire harness. Unscrewed ice maker mounting screws from mounting assembly. Reversed process to insta ll new icemaker. Be sure to turn ice maker plug assembly to fit in holder on back of assembly and tape back in mounting assembly so assembly wil go all the way back in the door without forcing. If done properly, the ice bucket will slide in easily and the door to ice maker compartment will close easily without any problems.
Was this helpful?
Thank you for voting!
Cracked door basket
  • Barbara J from Marietta, NY
  • Really Easy
  • Less than 15 mins
Just set the new one in- perfect and the delivery was ultra fast !!
Was this helpful?
Thank you for voting!
broken glass shelf
  • JOHN from LINCOLN, CA
  • Really Easy
  • Less than 15 mins
open the box cleaned the glass put it in the refrigerator
Was this helpful?
Thank you for voting!
All Instructions for the LSFS213ST
76 - 90 of 91