LSFD2591ST LG Refrigerator - Parts

The water reservoir holds the water for the water dispenser as the water chills.

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Tired of your fridge not making ice? This LG ice maker kit could be the fix. It freezes water into cubes and uses a built-in heater and thermostat to pop them out when they’re ready. It’s a genuine part made to fit LG models and can make up to 14 cubes at a time. Easy to install and built to last—just check your fridge model before ordering!

The compressor overload protector attaches to the compressor and shuts off the compressor if the compressor motor draws too much current.

This pipe holder secures tubing or piping in place to maintain proper alignment and routing. Its durable construction supports stable installation and reliable operation.

Frost near the door or a freezer that runs often may have a damaged door seal. The flexible gasket blocks room air and moisture from entering the cold compartment. First clean the seal and contact surface, then check the hinges and door fit. Match the replacement to the complete freezer model and door position. If shipping leaves folds, s...Read moreoak the gasket in warm water for 5 to 10 minutes or use a hair dryer on low. Do not overheat the rubber. Smooth each side, close the door, and test the seal with a strip of paper.