- Home
- LSC27921ST
- Instructions
LSC27921ST (02) LG Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
interior lights stay on
-
Rich from Pequannock, NJ
- Really Easy
- Less than 15 mins
-
Screw drivers
Changed door switch. Repair worked for a few days but re-occured. Possibly the other switch is bad .
Was this helpful?
Thank you for voting!
Manufacturer Cahnged Part Desin
-
David from Lewisville, TX
- Really Easy
- Less than 15 mins
Not the fault of partselect. The manufacturer had decided to modify my part and still specifying that it was the NEW part number and that it was the direct replacement (shame on LG). Well its not the same part. The partselect CSR worked with me to try and find the previous design to no avail, even going so far as to give me the phone numb
... Read more
er of an obsolete parts seller... wow! Without a whimper parts select credited my account for the part that would not fit!! Without a doubt I will use them again. Way to stand behind your sale!! And also I got the parts within two days, amazing. The ones that did fit were well packed in perfect condition and on time. DON'T HESITATE TO USE THIS COMPANY
Read less
Was this helpful?
Thank you for voting!
My ice maker overflowed water and made a mess in the freezer
-
steve from clarence center, NY
- Really Easy
- Less than 15 mins
-
Screw drivers
The part was extremely easy to replace. The unit came out with one screw, and I had to unplug the wire connection. After removing I noticed the ice tray was cracked - that's what caused the problem. The new unit went in easily with 1 plug in connection and 1 screw. I was done in less than 10 minutes.
Was this helpful?
Thank you for voting!
Ice cubes did not drop out of tray when the ice maker cycled
-
Michael from Eagle, WI
- Easy
- 15 - 30 mins
-
Screw drivers
1) Take out 3 screws from top of icemaker. 2) Unplug electrical connector from wiring harness. 3) Remove icemaker unit from freezer and then remove frozen cube sensor with clip and rear insulation. 4) With your hands pull cube tray motor out of the holding clips with the tray- if this is too difficult, spread bracket and only remove the t
... Read more
ray from the unit. 5) Insert new tray into slots and install new or existing ice sensor, insulation, and sensor clip. 6) Reinstall icemaker unit to ceiling of freezer, don't forget to plug into wiring harness. 7) Turn unit on and make some ice!
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Ice tray was bent and spilling water onto ice making it freeze
-
William from Nolensville, TN
- Really Easy
- 15 - 30 mins
-
Screw drivers
I took the ice out with one screw and took out the old tray the new one slipped right in and I hooked up the little heat strip with one snap works perfect cost $10 I was told by appliance repair tech that I needed to replace the ice maker for $450 saved $440 dollars replacing the bent or warped ice tray
Was this helpful?
Thank you for voting!
Threads were striped on water valve leaked needed new one
-
Nicholas from Melborne, FL
- Easy
- 30 - 60 mins
-
Screw drivers, Wrench set
Shut water valve off drained water in refrigerator instAlled new valve
Was this helpful?
Thank you for voting!