All Installation Instructions for LG Refrigerator LRTC19314ST

old bushing worn and broken

removed the upper freezer door to access screws to remove lower door.
laid bottom door on its side, removed bad bushing, put new bushing in, put bottom door back on refridge, put upper door back on fridge. Door worked easy as when new. good closure of door and story..Happy customer, and wife even happier.....thank you....

Parts Used:

Bushing

Jerry from CORSICANA, TX
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set

22 of 42 people found this instruction helpful.

Was this instruction helpful to you?

bottom door dropped slightly and bottom hinge area rubbing on steel door support

removed 3 fasteners for top door and placed freezer door aside, then removed 3 more fasteners on bottom refrigerator door and place that aside. replaced bushing on lower door bracket and reversed the above procedure to reinstall doors.

Parts Used:

Bushing

Louis from PHILADELPHIA, PA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set, Wrench set

12 of 27 people found this instruction helpful.

Was this instruction helpful to you?

two screws and done

part fit into slot and screwed them down

Parts Used:

Lower Holder Cover

Daniel from TROY, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

5 of 7 people found this instruction helpful.

Was this instruction helpful to you?

The ice maker in freezer P/NO 5988JA0002Y would leak water and make giant ice block

I ordered and replaced the ice maker. To replace:

1. Go behind refrigerator and unplug electrical cord and turn off water supply.

2. In freezer locate electrical plug for ice maker. It has two tabs on the left and right side of it. Lift the tabs and pull the plug to disconnect it.

3. Remove the three screws, 2 on top and 1 on bottom of ice maker You can actually leave the screws in place if you loosen them sufficiently and lift the ice maker off of the screws and washers.

4. Install the new ice maker using the screws and plastic washers to secure it.

5. Plug the electrical connector for ice maker into the receptacle. Note: The plug only goes one way and is keyed with different shaped plugs and holes. The wires on my plug naturally fell upside down so I had to turn the plug 180 degrees to make it fit in the slot.

6. Turn on water and check for leaks.

7. Plug back in refrigerator and you should have ice in less than 12 hours.

Parts Used:

Ice Maker Ice Maker Assembly

Eric from SURPRISE, AZ
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

5 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Broken clip that keeps the lower holder cover from falling off bottom of refregerator

Used a screwdriver to take off broken clip and then used same screwdriver to replace with new clip. Very easy.

Parts Used:

Lower Holder Cover

Renita from FORT MADISON, IA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Ice maker not working but making a sound when turned on (buzzing). Water valve not functioning when tested with a multitester (multimeter).

I removed the old water valve, disconnected the water tube going in and tube going out to the back of the refrigerator. New water valve bracket different than the previous one which resulted in my having to modify it to fit. Not an easy task as it was preformed metal. Once hooked up, water turned on, and ice maker turned on, the sound I'm getting now is clunking and not making ice. My debate is whether or not to purchase a new ice maker or revert to the tried and true method with ice trays which work every time.

Parts Used:

Water Valve Assembly

shirley from FLORISSANT, MO
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers, Wrench set

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Replace lower grill bracket

Pull off the grill cover and remove the 2 screws from the old part and simply screw in the new part. Don’t lose the screws there are no new ones with the new part. Replace cover.

Parts Used:

Lower Holder Cover

James from DICKSON CITY, PA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Not making ice but could hear the solenoid trying to work

I turned off the water supply. Took off the access panel at the bottom of the fridge. Disconnected the waterlines from the valve. Remove the screw hole in the valve in place install the waterlines on the new valve attach the new valve to the refrigerator, reinstalled the back panel turn on the water And it made ice.

Parts Used:

Water Valve Assembly

Jesse from Pella, IA
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench (Adjustable)

1 person found this instruction helpful.

Was this instruction helpful to you?

Left door when opened the light wouldn’t come on. Checked the light, ok. Ordered push button switch

Removed the cover 2 screws
Squeezed the 2 side sleeves and removed
Snapped in new button, replaced the cover. Done

Parts Used:

Push Button Switch

Richard from TULLY, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Wrench (Adjustable)

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

drawer was broken and replaced it

Just put the drawer in and it was ready to go. Like those kind of repairs

Parts Used:

Meat Tray Assembly

Ilene from Lincoln, NE
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Frig door not closing on its own accompanied by grinding sound

IMPORTANT: REPAIR EASIER WITH ASSISTANT! Pull frig from kitchen cabinets & unplug. Remove food from freezer & frig doors. Have assistant hold freezer door closed against freezer. Remove hinge cap from top of freezer along with hardware using socket wrench. Carefully lift freezer door from hardware that joins the bottom of the freezer door to the top of the frig door. Rest freezer door upright off to the side. Have assistant open frig door & SUPPORT BOTTOM. Remove hardware from top of frig using crescent wrench & screwdriver. Carefully lift frig door off joint & lay on side to gain access to hardware on bottom. Remove hardware using a screwdriver & replace worn nylon bushing. Reverse disassembly steps. Remove frig & freezer door shelves & clean inside. Clean outside frig, especially the back vents. Clean the floor where frig lives & push back into place. Enjoy clean SELF-CLOSING, NON-GRINDING frig door!

Parts Used:

Bushing

Joseph from Pennsville, NJ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Socket set

1 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Frost in the freezer. Icemaker frozen.

I called LG and followed the instructions given over the phone. The instructions couldn't have been simpler. Disconnect the appliance for several hours and then connect again. I disconnected the appliance overnight, cleaned out the freezer, and reconnected it. Problem solved. Did not need to call a repairman and did not use the clips.

Parts Used: