My Orders
- Home
- LRSC26920TT
- Instructions
LRSC26920TT LG Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
light was not going on sometimes, or needed wiggling to work
0 of 1 people
found this instruction helpful.
-
Nancy from Hallandale Beach, FL
- Really Easy
- Less than 15 mins
-
Screw drivers
purchased a new switch. The old switch just needed to be lightly pried out with a screw driver, then it was simple to unplug the old, and plug in the new. Voila! Light !
Was this helpful?
Thank you for voting!
The ice maker door stay open. And not close back.
0 of 2 people
found this instruction helpful.
-
Toai from Monroe, WA
- Really Easy
- Less than 15 mins
-
Screw drivers
So easy that my 13 years old son replaced it.
Was this helpful?
Thank you for voting!
Water/ice maker not working
9 of 38 people
found this instruction helpful.
-
Brent from ROGERS, MN
- Really Easy
- Less than 15 mins
-
Screw drivers
Remove push plate for water/ice maker switch, remove 2 screws and 2 wires for switch. Replace with new.
Was this helpful?
Thank you for voting!
Each time we've had to move we have to remove the doors from the fridge to get it thru the front door.since water and ice run thru the freezer door there are 2 tubes that connect at the bottom of the freezer door that aren't meant to be separated very often if ever.it's easier to cut the tubing on b
-
Sarah from Elk Grove, CA
- A Bit Difficult
- 15 - 30 mins
-
Pliers
With alot of elbow grease and a pair of pliars we managed to get the old connector off wo cuttig the tubing as the tubing was getting to short from being cut once to many times & there was no more play in the length.Original connector was a different color and shapped slightly different than the new one so was a bit concerned that I had
... Read more
ordered the wrong part but it went one very easily & did not leak. We even managed to remove it again just to see if it was possible wo cutting again. it came off with no trouble.I would say the replacement part was a better fit than the original simply because we could remove it easily wo having to cut the tube!
Read less
Was this helpful?
Thank you for voting!
Continuous clicking and not cooling
-
Mark from Little Mountain, SC
- Easy
- 15 - 30 mins
-
Screw drivers
Removed rear cover from refrigerator, removed starter relay/thermal overload cover from compressor, removed starter relay and thermal overload protector from compressor, installed new relay and overload protector, replaced the compressor cover and replaced the refrigerator cover.
Was this helpful?
Thank you for voting!