LNC7766B71 Admiral Dryer - Parts

This dryer drum belt has four ridges, three grooves and is 1/4" wide.

This kit comes with three separate thermal fuses and is usually used with clothes dryers that have a fan mounted on the motor shaft. Included within this kit is the high limit (Limit: 258) the gas high limit (Limit: 240) and the gas and electric high limit thermostat (Limit: 300).

If your clothes are taking longer to dry or coming out with lint, it might be time to replace your dryer’s lint filter. This easy-to-install part catches lint and debris during each cycle, helping your dryer work better and keeping your clothes cleaner. Just slide out the old filter and pop in the new one—it’s a quick fix that can make a big difference in drying performance and safety.

This kit comes in two pieces: the catch and the clip.

This 240-volt, 4750-watt heating element kit is designed to restore proper heat output in select dryer models. It generates the heat necessary to dry clothing efficiently during each cycle. If your dryer is taking longer than usual to dry clothes or isn’t producing heat at all, the heating element may need replacement. Installation requir...Read morees disconnecting the power and using basic tools such as a putty knife, quarter-inch nut driver, and needle nose pliers. This kit is sold individually and does not include additional accessories.

This wheel has a deep D-shaped shaft receptacle. The spring clamp is not included with this part.

Included in this rear drum support roller kit are 4 screws, 1 spacers, 2 washers, 2 retaining rings, 2 rear rollers, and 2 cylinder support shafts. *** Note: Per manufacturer this kit has been updated now to have one spacer that is the thickness of 2 spacers. To get these parts separately, please search by model#.

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

This screw is sold individually.

This is the replacement motor pulley for your dryer. The motor pulley transfers momentum from the drive motor to the drum via the drive belt. If the motor pulley cracks or is no longer staying on the drive shaft, you will need to replace it. You will need to access the dryer motor for this repair, by removing the front panel. The motor pu...Read morelley is approximately 1 inch in diameter and is sold individually. This is an OEM part sourced directly from the manufacturer.

This screw is sold individually.

If this part appears to be too wide for your particular appliance, per the manufacturer, all you have to do is pull it apart.