LFX31925SW (ASWCNA7) LG Refrigerator - Parts

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

The compressor overload protector attaches to the compressor and shuts off the compressor if the compressor motor draws too much current.

Frost near the door or a freezer that runs often may have a damaged door seal. The flexible gasket blocks room air and moisture from entering the cold compartment. First clean the seal and contact surface, then check the hinges and door fit. Match the replacement to the complete freezer model and door position. If shipping leaves folds, s...Read moreoak the gasket in warm water for 5 to 10 minutes or use a hair dryer on low. Do not overheat the rubber. Smooth each side, close the door, and test the seal with a strip of paper.

This rail connector is a replacement structural component designed to join and stabilize sliding or support rails. It ensures smooth movement and alignment and is commonly replaced when worn or broken.

This PTC thermistor assembly plays a crucial role in maintaining your refrigerator’s performance by regulating internal temperature and assisting with compressor start-up. Designed for select models, it monitors temperature changes and communicates with the control board to ensure consistent cooling. The assembly includes the necessary wi...Read morering and ground cable for installation, making it a reliable replacement for restoring proper operation and preserving food freshness.

This evaporator fan motor assembly circulates cold air throughout the refrigerator and freezer compartments, helping maintain steady, even temperatures for reliable cooling performance. The energy-efficient DC motor moves air across the evaporator coils and distributes it through the interior vents, preventing warm spots and ensuring prop...Read moreer food preservation. When this component begins to fail, you may notice symptoms such as excessive warmth inside the fridge, unusual noise coming from the freezer area, or a fan that no longer runs. Installation typically involves removing the freezer’s rear panel, disconnecting the old motor assembly, and securing the new one in its place to restore smooth, quiet airflow.

If your fridge isn’t making ice or dispensing water, this water inlet valve could be the fix. It controls the flow of water to the ice maker and dispenser, helping everything work like it should. Easy to install and built to last, this genuine replacement restores your refrigerator’s performance quickly.