All Installation Instructions for LG Refrigerator LFD25860ST

water supply to ice maker leaked

Gave model number on website, found picture of icemaker section. Ordered part that came in 3 days and switched old for new

Parts Used:

Plastic Tube - 5/16 Inch

john from locust valley, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

light out

slid screw driver under edge of switch, easy.

Parts Used:

Refrigerator Door Switch

Jack from Ellenton, FL
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Unit kept beeping as if the freezer door was open

I popped the old switch out of place and then disconnected the wire harness from the switch with a pair of needle nose pliers. I then inserted the harness into the new switch and popped the switch into place. Super easy and fast.

Parts Used:

Refrigerator Door Switch

Paul from San Jose, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

plastic tube leaking at connector

Uncoupled the old connector, replaced with new connector and attached supply line. Repair easy with right part, prior to ordering the right part I had tried a compression fitting and it still leaked. U-tube and others demonstrating repair assured me I was on the right path.

Parts Used:

Holder,Bracket

GREG from STILLWATER, NJ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Wrench (Adjustable)

1 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Crack In Old Tank Assembly

Removed the old, replaced with new. . . That easy.

Parts Used:

Water Tube

Mark from Port Angeles, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Frost in the freezer. Icemaker frozen.

I called LG and followed the instructions given over the phone. The instructions couldn't have been simpler. Disconnect the appliance for several hours and then connect again. I disconnected the appliance overnight, cleaned out the freezer, and reconnected it. Problem solved. Did not need to call a repairman and did not use the clips.

Parts Used:

Clip

Teresa from Miami, FL
Difficulty Level:
Really Easy
Total Repair Time:
More than 2 hours

1 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Water/ice maker not working

Remove push plate for water/ice maker switch, remove 2 screws and 2 wires for switch. Replace with new.

Parts Used:

Micro Switch

Brent from ROGERS, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

9 of 37 people found this instruction helpful.

Was this instruction helpful to you?

Broken tab on hinge of drawer crisper

Replace the drawer crisper

Parts Used:

Crisper Drawer Front

Jim from Indian Harbour Beach, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

broken

removed 1 screw and replaced

Parts Used:

Cam,Shaft

Refrigerator Camshaft

william from mashpee, MA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Plastic door latch/ cam shaft broke on left side door

Removed white plastic trim and installed new latch / cam shaft

Parts Used:

Cam,Shaft

Refrigerator Camshaft

Reginald A. Green from Pelham, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Broke the crisper drawer front

While cleaning out the frig we removed the bottom shelf to remove the glass and really scrub it down. When we went to put it back in, my wife grabbed the crisper door front and snapped it offf. I immediately went to the computer to find a replacement part and found PartSelect.com. I plugged in the model number and I immediately saw a diagram to pick out my part. I had it ordered before she got all the food back in the frig! The part arrived early and I installed it in a matter of seconds. So easy to find the part, order it and install. You have a new customer!!!

Parts Used:

Crisper Drawer Front

Johnny from Acworth, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

mounting tabs broken off

slightly depressed tabs, lined up to mounting holes, released tabs.

Parts Used:

Crisper Drawer Front

Brent from Cordele, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Interior Light Would Not Turn Off

Tape off the light button so door alarm does not go off. Take off the clear light shield and remove the light bulbs. Be careful, bulbs may still be HOT!! With Phillips head screw driver unscrew the light plate assy. Drop it down in a comfortable position. Disconnect the connector, unscrew the thermal sensor and remove light assy. Install new light assy into light plate assy. There is no thermal senor in the new assy. Snap light plate assy back into place and install the two screws previously taken out. Install bulbs and clear cover. Remove tape from light door switches and you are done. Lights should go on and off when door buttons are pushed in and out.

Parts Used: