LCE462AL1 Frigidaire Washer - Parts

If your washer isn’t filling properly, leaking, or not cleaning clothes like it should, the water inlet valve might be the issue. This part controls how hot and cold water flows into your machine. It’s easy to install and comes with the bracket and screws you need. Just make sure it fits your model, and turn off the power and water before starting.

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Sold individually.

Sold individually.

This washer spin bearing supports the drive shaft and helps the drum spin smoothly during the spin cycle. Located at the bottom of the outer tub, it plays a key role in reducing friction and noise during operation. Replacing a worn or damaged bearing can help resolve loud or unusual noises and restore proper spinning performance.

Holds plated on Trunion .312-18 x 1.625.

This part helps with the spinning and agitating cycles.

This part is used to activate the lid switch when the lid opens/closes.

This spacer goes between the timer knob and the dial.