LA5500XSW0 Whirlpool Washer - Parts

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

This part gets the motor up to speed quickly before transferring power to the run capacitor.

This part is the replacement water inlet hose for your washer. It is black in color, made of plastic, and is approximately 19 inches long. The water inlet hose connects the water inlet valve to the water fill nozzle. Over time the hose can become cracked and damaged, and this can cause it to leak. A damaged hose will need to be replaced. ...Read moreBe sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.

Used to drain water.

Sold individually.

This spin tube T-Bearing is an inch long. Sold individually.

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Note: This part has been updated by the manufacturer. It may appear different but will still function the same as the original.

This basket drive assembly is for washers. Basket drive assembly sits on top of the transmission shaft and houses the spin basket brake mechanism. The basket drive spins to rotate the basket during the spin cycle.

This clamp helps to prevent leaking by holding the end of water hose in place.

If your washer is noisy or shaking, the spanner nut might need replacing. This part locks the inner tub to the drive block so it spins smoothly during cycles. It has a right-hand thread and is easy to install with basic tools—just make sure the washer is unplugged and water is turned off before you start. A simple fix for a quieter, more efficient wash.