My Orders
- Home
- KUIA18NNJS3
- Instructions
KUIA18NNJS3 KitchenAid Ice Maker - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
condenser fan motor quit
-
Thomas from Rensselaer, NY
- A Bit Difficult
- More than 2 hours
-
Nutdriver, Socket set
Technically, the repair did not require specialized knowledge. However, replacement of the motor required some effort. Because the motor is located at the bottom of the unit in an area with copper tubing & wiring hindering access it was physically difficult to remove and then replace the motor. A problem arose because the shaft on the
... Read more
replacement motor was larger than the original motor's. Thus the fan would not fit on the new motor. Luckily, I found a fan locally that fit the motor. It would be very helpful if a fan was included in the motor kit. The ref. is now running smoothly
Read less
Was this helpful?
Thank you for voting!
Hard water deposits salted pump motor
-
David from Friendswood, TX
- Really Easy
- 30 - 60 mins
-
Nutdriver, Pliers, Wrench (Adjustable)
Disconnect water line and power cord, Remove scoop holder, water reservoir and shield around pump to access pump, removed hose connected to pump then removed pump (3- 1/4" hex screws) and disconnected wire harness and 1/4" plastic water line attached to pump bracket, reverse process
Was this helpful?
Thank you for voting!
cutting grid wire broke
-
Dean from Anchorage, KY
- Really Easy
- 30 - 60 mins
-
Nutdriver, Socket set
Bought new wire, strung it end to end and fastened it at each end.
Was this helpful?
Thank you for voting!
Unit Running Hot
-
BRUCE from KRUM, TX
- Really Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers, Socket set, Wrench (Adjustable)
Insalled fan motor,problem went away. Thanks
Was this helpful?
Thank you for voting!