KUDP02FRWH2 KitchenAid Dishwasher - Parts

This is the replacement impeller kit for your dishwasher. This impeller kit comes with 4 pieces, including the impeller and seals which you will need for the repair. The impeller and seal kit is mounted on the dishwasher motor. If your dishwasher is not cleaning dishes properly, it may be an indication that your impeller has gone bad, and...Read more you are not getting proper water pressure. If the seals have gone bad, your dishwasher may start to leak. If you are having either of these problems, you may need to replace the impeller kit. Be sure to disconnect the water and power source from the dishwasher before you begin this repair. This is an OEM part sourced directly from the manufacturer.

This seal is located between the spray arm and the water feed tube.

Also known as a wash arm seal.

This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.

May differ in appearance, but functions same as original. This valve allows the water to flow in the drain direction only and prevents the dirty water from coming back into the tub.

Help protect the dishwasher from overheating with this high-limit thermostat. Mounted beneath the tub, it responds to excessive heat by cutting power to the heating element. A failed thermostat may interrupt heating, leaving wash water too cool or dishes wet after the drying cycle. Replacing a faulty unit helps restore the heater safety c...Read moreircuit and proper heating operation. This temperature-sensitive switch works as a protective limit during use. Disconnect electrical power before accessing the underside of the dishwasher or removing any wiring.

Sold individually. Used with the heating element.

This rinse aid cap or fill cap is for your dishwasher and it screws into the jet dry dispenser. Sometimes the cap can become loose and fall out, which can cause it to melt from the heater. If your cap is damaged or missing, this is the part you will need to replace it. It is made of white plastic and is a little more than an inch in diameter. This rinse aid cap is sold individually.

The tine row is located on the lower dishrack. The tine row can be raised or lowered to provide more room in the lower dishrack. Over time the tine row can become rusted, damaged, or lost, and will need to be replaced. The manufacturer has updated the tine row, it may look different but it will still fit like the original. This part measu...Read moreres approximately 19 1/2” long and is made of metal. This is a genuine OEM part and is sold individually.

This dishwasher door latch assembly is a precision-engineered component designed to secure the door during operation, ensuring a watertight seal and uninterrupted wash cycles. Mounted at the top of the dishwasher door, it engages with the strike to keep the door firmly closed, preventing leaks and enabling proper function of the appliance...Read more’s internal systems. Constructed from durable materials, this genuine replacement part restores reliable performance in units experiencing issues such as door misalignment, failure to start, or water leakage. Installation is straightforward and typically requires only basic tools. Replacing a worn or faulty latch helps maintain safety, efficiency, and overall dishwasher performance.

This seal is attached to the inner cabinet to reduce noise.

Measures level of soil in the water.