KFIL27CXMS5 KitchenAid Refrigerator - Instructions

installed new parts

I unscrewed the screw holing the coupling in place.Made sure the washers whereput back in right and put the new coupling in and retightened the screw on the auger that holds the coupling in place and then put the ice bin back in place and away it went.

replaced electric control board, defrost for six hours. next day (24 hours) same problem, [email protected]

I used a knife blade to slip under the edge of old switch to pray it out of the hole it was inserted into, switched the wires and replaced the new switch into the same hole. It took about five minutes!

Just like the video showed me.It still does not work. Have to turn it off and on to make it start up.I also replaced thermostat in freezer. Does not work.

Extemely easy to install. I just found the model number on ther refridgerator, ordered the part, the part was shipped very fast, installed the Coupling with a small screw driver in less than 5 minutes! I saved myself a lot of money! I am a female and it was very easy to do!

I removed the ice bin and on the bottom of it I removed 1 screw. I put the washer and drive lug on and reattached the screw. It was so simple I thought I surely left something off. It has worked fine since.

Poped ou the old switch, connected new switch and pushed back into socket.

The old coupling was no longer in the unit so I took out the set screw inserted the new coupling and reset the screw and now my ice maker works again like a champ. Less than 10 minute repair but took an extrea 5 as I had to mnake a new washer that goes under the coupling for wear resistance.

Simply removed screw, replaced coupling and screwed back into place. Took less than a minute. Good as new!

Removed the screw at the base of the ice bin unit. Replaced the coupling that had broken teeth and screwed in the new one. Was very simple. With service call with part near $150 the repair was made for less than $20.

First I lifted the ice bucket out of the refrigerator, the broken coupling fell out in three pieces. I ordered a new coupling {$14 including shipping) It arrived 4 days later. I removed the phillips screw and installed the new coupling along with the flat washer that had fallen out. The repair took 5 minutes and saved a lot of money.

The ice dispenser stopped turning for crushed/cubed ice out the chute. Turned out it was this little $10 metal coupling part that broke apart. I'm guessing its not an unusual problem because the partSelect part was redesigned to be thicker than the original part to help prevent it from happening. I was very impressed with the superiour quality of the replacement part.

Dropped down the housing for the water filter, twisted, removed item and slotted in the new filter. Easy as pie.

I removed the ice bin to clean out the ice when I noticed the broken part under the bin. I went to my local parts supplier and was told I had to replace the entire bin and assembly for about $185. I found your web site and recieved the part the next morning for $17 including shipping. It was repaired in 5 minutes. Thank you Parts Select.