JGP933SEKS General Electric Range - Instructions

took burner off installed new one thank you for fast shipping

It only required placing the new burner in the proper location.

Got ignitor and it did not have wire attached as shown in the picture of parts. However, all I did was take burner cap off, and gently life ignitor up and out, detach the wire, attach new ignitor to wire and reset.

I got really great customer service on finally getting the right part. It came really fast it fit perfect but the cap is a high gloss black instead of a flat black. I will need to call customer service again to see if they can the correct color this time.
Otherwise everything was great!

Replaced starter switch harness as well as igniter module. Cost was around $70 for parts. Cheaper than a new cooktop.

the electrodes on this model have to be removed before you can raise cooktop, once cooktop is raised remove wire from burner bracket, use needle nose pliers to squeeze bottom of clip,remove &replace with new parts.

replace knob your telephone person was wonderful helped me find the right knob

there were no grate pads so it was easy to add them.

I had to drill the hole to a larger size to enable the foot to fit.

Nothing technical.

Used scribe to remove grate foot plug still in grate inserted new foot.

Start by removing all screws 3 for each burner total of 15 t-15 bit is required then proceed to remove spark igniters 5 total slight pull next step would be to slide a screwdriver under top left and right side to remove top shelf. There you will have access to the parts you need to replace. When done just reverse installation instructions to complete

Ordered and was quickly shipped and received. Very happy with service.

Thank You,
Donald Torreson

Simply took off the burner head and burner cap, and replaced with the new ones. No tools, very simple, less than 5 minutes. Problem is fixed.

First remove the screws around the inside perimeter of the door. These require a special hex driver. Take off the inside plastic liner of door.
Peal off the old Insulation Foam Strip and replace it with the new strip in the same location. Make sure the wires are off to the right side. Replace the door plastic liner. Done. The Insulation Foam Strip really acts more like a loose gasket to keep spashing from creeping under the door and drippin out on the floor.