JGBP27GEN1 General Electric Range - Instructions

Removed the screw from the broken piece and put the new piece on and put the screw on.

layed the range on its side and removed the gas valve installed the new valve leak checked and tested works like new. Great service and parts availability, shipping was fast.

removed two rear screws, pulled out range bottom, dropped new one in place, and reinstalled screws...VIOLA! works like a charm. I'm a woman and 53 years old ...If I can do it... you can too!

I was so sick of this drawer and I over heard a buddy telling a story about a website that you can get ANY piece for appliances. I take the drawer out, look up the website (partselect.com) look at the appliance diagram and find the missing piece. Order it, get it, install it. My wife thinks I'm a hero and I think I'm pretty cool too.

Remove drawer by pulling out and lifting up so drawer will slide out of range. Use 1/4 inch Nutdriver or socket - remove the screw that holds the drawer support to the body of the range. Remove support and install new one with screw Pay attention to the way the support fits. There are two holes one for the screw and the other for the plastic prong on the bottom of the support. The prong fits in the bottom hole and the screw in the above hole.

First diagnose where the smell of natural gas is coming from, mine was the range. On my model oven there is a small red shut off valve on the regulator. Turn that valve of and see if the smell goes away. If it does then the problem is with the Dual Oven Safety Valve. Order a new valve. First shut off gas to oven and disconnect gas line. I found it easier to replace the valve with the oven on its side. Once you find the valve location loosen the 3 gas lines and remove two mounting screws that hold the valve to the oven frame. Remove old valve and install new in reverse order. Be careful when reconnecting the 3 gas lines not to cross thread or over torque. Reconnect gas line and turn on gas.