Models > JES1334WD001 > Instructions

JES1334WD001 General Electric Microwave - Instructions

All Instructions for the JES1334WD001
76 - 77 of 77
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
diode burnt
it was a simple screw in on both ends. no soldering
Parts Used:
Diode
  • MANUEL from ESCONDIDO, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Microwave inoperative no power to display
Remove the back cover screws and remove back/top. Locate the thermostat and remove the two Phillip screws. Cut off old scorched terminals and replace with new terminal connectors on the wire ends and install new thermostat and reassemble.
Parts Used:
Thermostat
  • Fuller from Gulfport, MS
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the JES1334WD001
76 - 77 of 77
Back to Top