All Installation Instructions for Jenn-Air Dishwasher JDB8200AWS1

Upper dishwasher rack broken

Removed the old rack clips from the top rack, freeing the rack and removed the bracket holding the adjustable bracket

Replaced the rack bracket and hung the rack back onto the rails

Parts Used:

Dishwasher Upper Rack Adjuster

James from ELGIN, OK
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

The wheels would not roll.

Replaced the wheels.

Parts Used:

Lower Dishrack Wheel

Bill from CYPRESS, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Dishwasher wasn't draining

Took minutes to repair. Unhooked the electrical plug connector to the drain pump. 1/4 turn to the left and pump was off. Just the opposite to install new pump

Parts Used:

Dishwasher Drain Pump

James from NEW BERLIN, WI
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

none

removed and installed cords with screw driver

Parts Used:

Power Cord Kit

Ronald from VAN BUREN TWP, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Broken plastic piece in door balance link kit

Watch video and followed instructions. Very easy!

Parts Used:

Door Balance Link Kit

Pauline from FERGUS FALLS, MN
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Wrench (Adjustable)

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Retainer came off and was partially melted during a wash cycle

Called and with the help of Brandon in customer service the part was ordered,. It was a simple fix.. just snapped into place. Thanks!!

Parts Used:

Retainer

Sharon from YORKVILLE, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

The Door Leveler Nylon Cord assy broke

It was very easy.

Parts Used:

Door Balance Link Kit

Robert from Highland Village, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Broken cord on door balance

Very easy. I removed the two screws on the base plate, then the two screws that attach the washer to the cabinet, and pulled the washer out of its slot. I installed the broken side and closely checked the other side and felt it didn't need repairing. I put it back together and the door works very well.

Thanks,
Ted K.

Parts Used:

Door Balance Link Kit

Ted from Santa Clarita, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Socket set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Dishwasher door had lost springback

1) Pull out dishwasher from under counter. 2) Disconnect spring located at the bottom on each side of dishwasher. 3) Using socket remove pulley wheels from each side at bottom. 4) Install new pulleys on each side. 5) Wind pulley cord around both wheels and attach to one end of the spring on each side. 6) Using pliers extend other spring end to lower frame of dishwasher on each side. 7) Open and close dishwasher door to test. 8) Replacement complete

Parts Used:

Door Balance Link Kit

Peter from BIRMINGHAM, MI
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Socket set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Washer would not turn on

Watched a video and read through written directions.
Did not need to pull out the dishwasher from the cabinet.

Parts Used:

Door Latch - Black

Lucille from MODESTO, CA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Dish washer was very smelly.

After replacing garbage disposal. I referred to you video you sent me when i received the new replacement hose. That made it look very easy to install. Thank you for all your help and support.

Parts Used:

Drain Hose

Robert from Des Moines, IA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers, Wrench set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Dishwasher was leaking at the bottom edge of door.

Ordered the door gasket and replaced it. Worked perfect. The trick was to stretch the gasket a little as it went around the top curvatures. It would stick out some and not sit as flat as on the top and sides. This helped it to flatten down better.

Parts Used:

Dishwasher Seal

robert from SOUTH HADLEY, MA
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Replacing broken adjuster housing cover.

Take out the upper dishwasher rack. Place the adjuster towards the back of the upper each place attachment clips to secure adjuster and the adjuster clips to the back of the housing. Check to back sure adjuster move up and down and click back into place. Your installation is complete. Good luck!

Parts Used:

Dishwasher Upper Rack Adjuster

Dishwasher Adjuster Housing Cover

Cassie from RIVERDALE, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Develeoped a leak on the bottom.

Pulled dishwasher out of compartment, removed all parts underneath. removed inner parts, removed pump assembly. Installed new pump assembly and grommet. Reassembled in reverse order, test ran and unit was operating normal and no leaks.

Parts Used:

Dishwasher Grommet

Eladio from LOGAN, OH
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers, Wrench (Adjustable)

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

PartSelect Scammers

PartSelect intentionally shipped obsolete part that could not possibly fit a dishwasher. The part looked to be a rectangle door seal for a freezer/ref. You make it impossible to return the part. I find it interesting that you sent the correct install video and wrong part.
Suggestion: After you print a shipping label take a picture of the part and shipping label before it is boxed. The customer should not have to send you a picture of the wrong part and the serial number of the appliance for a refund. You did not need the serial number to ship it.

I will never use your company again William Dewberry

Parts Used: