Models > JCP350BA1BB > Instructions

JCP350BA1BB General Electric Cooktop - Instructions

All Instructions for the JCP350BA1BB
31 - 35 of 35
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Cook top control stoped working
Just follow the directions on the website.
Parts Used:
SWITCH INFINITE CONTROL
  • Daniel from chesterfield, MO
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Burner would not work
turned off breaker feeding electricity to cooktop, pulled cook top out of counter top, removed screws holding glass to cook top, removed knobs, replaced switches, replaced everything in reverse order. before re-installing glass I turned power back on and tested burner for operation.
Parts Used:
Surface Element Switch - 1900W Surface Burner Switch - 6 Inch- 1200W SWITCH INFINITE CONTROL
  • Robert from Plaquemine, LA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Element would not turn off
Set cooktop circuit breaker to off.
Remove hold-down straps from underneath cooktop.
Lift cooktop from counter.
Remove screws holding glass top to base.
Remove screws holding switches
Remove two screws holding element switch.
Move wires from bad switch to new switch.
Reinstall.
Parts Used:
Surface Element Switch - 1900W
  • NEIL from FRIENDSWOOD, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Burner knob had broken
Just replaced the knob, no tools needed. The knob I ordered was the exact type of my old one so was no problem. Thanks for fast shipping and correct item.
Parts Used:
Surface Burner Knob
  • Hazel C. from Jonesborough, TN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Dual burner was only heating on high.
Getting to the control switch was the hardest. Handling our 35" cooktop was tricky. The rest went fairly easy. Just make sure you make a diagram of the colored wires and where they go on the switch. We had to expand the holes in the switch a little to get the old screws lined up.. Putting the cooktop back together was easy.
Parts Used:
SWITCH INFINITE CONTROL
  • Claire from Altoona, PA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the JCP350BA1BB
31 - 35 of 35
Back to Top