J-348 (Type 1) Porter Cable Jig Saw - Parts

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

It is a genuine OEM supplied replacement screw which is specially designed for use with power tools. This is one of the screws for the unit, please refer to the appropriate diagrams of your model for the correct location and use of this hardware. Please note it is made of high-quality metal and is sold individually.

This cord is a genuine Porter Cable replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 16 Gauge • 10 Feet Long

This screw is a high quality hardware that is designed for use with Porter Cable and Dewalt power tools. It has multiple applications depending on your tool, please make sure to check appropriate diagrams for correct location and use of this item. This phillips flat-head screw is sold individually.

This manufacturer sourced replacement part is designed for use with Delta and Porter Cable power tools. The purpose of the brush cap is to secure the carbon brush in the tool. This item is made from durable plastic and it is sold individually, to secure or remove it you will need a flat-head screwdriver.

This is a genuine OEM sourced replacement part which is specially designed for use with Porter Cable equipment. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

Genuine Porter Cable replacement part, this item is sold individually. This screw is used in various parts of the tools shown below. It can found in each of the tools securing different internal parts of these tools. It is a Torx T-25 screw.

This is an authentic replacement part that is used with blade welders, shears, routers, sanders, reciprocating saws, and laminate trimmers from Delta and Porter Cable. The metal screw is used with different types of machines and the application of the screw can vary based on the model of the equipment.

Genuine OEM Replacement Part used on a variety of Power Equipment. This part is made out of Metal and is Sold Individually. Terminal Eyelet allows you to safely and easily secure a wire to the needed part of the tool using only a screw.

It is a genuine item which is made for use with Porter Cable power tool. This part is supplied directly from the original equipment manufacturer. It is a special component which helps to connect two lead wires. The part is utilized to connect the on/off switch to the tool. It is a simple plastic item which is sold individually. Replacing ...Read moreit will only require a screwdriver, take apart the housing, remove the old part and secure the wires using the new connector.

Genuine Porter Cable replacement part includes 1 Carbon Brush with wire lead and brush spring attached.rn • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replace...Read mored power tool components. • Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. • Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. • A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. • When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.