HTWP1400F0WW Hotpoint Washer - Parts

This is a replacement screw for your washer. The screw has a hex head and is approximately 1 inch in length. The washer portion of this screw is approximately 1 inch in diameter. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

This screw is sold individually.

This part is able to sense the water level in the tub. When the water reaches the desired level, this switch stops the water from flowing in the tub and then the washing program begins.

This part is for the hose to outer tub.

Is your washer shaking, banging, or moving around during the spin cycle? It might be time to replace the rear suspension rod. This part helps keep the tub steady, especially when the load is off-balance. It cuts down on noise and helps your washer run more smoothly. If you’ve noticed loud noises or the tub looking off-center, this could b...Read moree the fix. It’s made for select GE and Hotpoint models, so be sure to check your model number before ordering.

Sold individually.

The triple water valve or inlet valve in your washer connects to the water source and solenoid wires, and ensures the tub has the right amount of water entering it. If your washing machine continues to fill after it is full, or if it fills slowly, you may need to replace this valve. Before you begin this repair, be sure to disconnect the water and power sources from your washer. This part is sold individually.

The lid covers the washer tub opening.