HT22 - Overview

Models starting with HT22

Keep searches simple, eg. "belt" or "pump".
Gear Box Cover - Ht-17 – Part Number: 00954
Gear Box Cover - Ht-17
PartSelect #: PS9866613
Manufacturer #: 00954
$5.95
  Special Order
Screw- Thread Forming 8-16 X 3/4 – Part Number: 82368
Screw- Thread Forming 8-16 X 3/4
PartSelect #: PS11898787
Manufacturer #: 82368
$5.95
  Special Order
Lever-Trigger – Part Number: 00959
Lever-Trigger
PartSelect #: PS9866619
Manufacturer #: 00959
$5.95
  Special Order
Pawl-Starter – Part Number: 00928
Pawl-Starter
PartSelect #: PS9866575
Manufacturer #: 00928
$6.95
  Special Order
Switch – Part Number: 00941
Switch
PartSelect #: PS9866603
Manufacturer #: 00941
$5.95
  Special Order
Tubing - Rubber – Part Number: 9477224
Tubing - Rubber
PartSelect #: PS16757107
Manufacturer #: 9477224
$24.95
  Special Order
Fuel Cap – Part Number: DA00099A
Fuel Cap
PartSelect #: PS10044425
Manufacturer #: DA00099A
$8.95
  Special Order
Clamp – Part Number: 98268
Clamp
PartSelect #: PS16757131
Manufacturer #: 98268
$5.95
  Special Order
Screw (ST-155) – Part Number: 82538
Screw (ST-155)
PartSelect #: PS16442489
Manufacturer #: 82538
$5.95
  Special Order
Spark Plug (Rdj-7y) – Part Number: 79252
Spark Plug (Rdj-7y)
PartSelect #: PS16756088
Manufacturer #: 79252
$5.95
  Special Order
Gear and Pin Assembly – Part Number: A01312
Gear and Pin Assembly
PartSelect #: PS16757291
Manufacturer #: A01312
$19.95
  Special Order
Blade Assy. 17-In. – Part Number: 07210
Blade Assy. 17-In.
PartSelect #: PS11897859
Manufacturer #: 07210
$75.95
  Special Order

Common Symptoms of models starting with HT22

[Viewing 3 of 3]
Will Not Start
Fixed by
these parts
Fixing
Show All
Engine stops after a few seconds or minutes
Fixed by
these parts
Fixing
Show All
Engine revs but trimmer head will not turn
Fixed by
these parts
Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Fuel line broke
Removed the two screws holding the fuel tank to the main unit. Removed the two fuel lines and any stuck on rubber. Installed and installed two screws to mount the new tank. Slid fuel lines on their respective connectors. Done.
Parts Used:
Fuel Tank Assembly
  • Erik from ROBERTSDALE, AL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
13 of 16 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
string trimmer would not start
emptied fuel from tank. pulled off the 2 fuel lines from the carburetor.opened the air cleaner door. removed the 2 torque screws that hold on the carburetor. removed the carburetor and air cleaner gasket. installed new carburetor and gasket and put back and tightened the 2 torque screws. closed air cleaner door and pushed the fuel lines onto the new carburetor.put some fuel in the tank. started the trimmer. runs great.
Parts Used:
Carburetor Gasket Trimmer Carburetor
  • john from SHARPSVILLE, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
6 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken power input terminal
I found this unit by the side of the road. One power input terminal was loose. Inside it was broken. Replacement was to remove the screws, pull out the wire, and cut the wire next to the terminal. I was able to strip the wire and crimp it in the terminal. I then soldered both terminals for a good connection.
Parts Used:
Contact,term.
  • Curtis from Huntsville, AL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
8 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!