HIIP056U/01 Bosch Range - Instructions

First, cut the power and remove the oven from the cabinet.

The bake element is accessible from the back and sits in a drawer.

As someone else said, you have to use pliers to bend the cover of the drawer, you will make some damage to the cover, but there is nothing you can do about it.

Make a note of what w ... Read more ire goes to the right and to the left so you can plug them back like it was before.

When you replace the bake element, make sure you insert it in the straps so it won't wiggle when it heats.

To close the cover that you bent, you will need a helper and push really hard.

Removed the wall oven to access temp probe connector strapped to the back of the oven. removed 2 screws holding probe inside the oven & replaced. Searched for the "fixing kit" thermostat part I was suggested to replace along with the probe. No thermostat type part was found in my oven, even though Bosch says it fits "somewhere". Reinstall ... Read more ed the wall oven & tested. The temperature is working normal now. Will return the fixing kit.

Watch the YouTube video.
Turn off power or unplug the range.
Remove 5 gas control knobs.
Remove four T20 screws on Control panel. one on each end, L and R, two underneath, L and R.
Pull off control panel and carefully flip it up onto the range, being careful not to stretch the wiring harness.
Carefully remove two ... Read more wiring connectors (pinch and pull method)
Remove four T20 screws securing the Control panel mount then turn it over 180 degrees.
Straighten the mounting tabs until the control panel easily slides off of its mount.
Remove and replace the control panel and sheet.
Reverse the procedure to reinstall.
It took me longer to clean the components and the area that to repair the problem.
Tip: Isopropyl alcohol in a spray bottle and a cloth cuts the grease and grime, if needed, with very little effort and no scratching.

Took the one out of the box and take off the back plate and detach the sensor

Turn off circuit breaker to cooktop.
Disconnect wires at junction box under the unit, making note of the color matching.
Gently remove cooktop from cutout and flip over, glass down, on a flat, soft, padded surface to protect the glass (I used placemats).
Remove the Philips screws around the perimeter of the sheet metal ass ... Read more embly enclosure box.
Lift the box straight up, revealing the inner assembly.
Look for the long, narrow PCBA (printed circuit board assembly) that is behind the touch controls.
Disconnect the snap-on electrical connector from the PCBA.
Gently nudge the small plastic clips at the edge of the PCBA to release it from its seating.
Install the new board in its place -- it should just snap into place.
Reconnect the electrical connector to the board, making sure it is properly aligned.
Replace the metal assembly cover and secure with the original screws.
Gently flip the cooktop over and lower straight down into the counter cutout.
Reattach the power wiring at the junction box and cover it with the j-box plate.
Turn on the circuit breaker.
Done!

installed new front glass panel.
installed thin magnetic catches on each side of door