GTW330ASK2WW General Electric Washer - Instructions

Unplug the cord and shut off hot and cold water faucets.

headache avoidance: The male threads of the inlet valve are plastic. Gently turn the female hose ends onto them at the kitchen table with the eventual position in mind then tighten.

1. Remove 4 screws holding shiny metal backplate w/ 1/4" socket (easy)
2. Pry tabs loose, top of plate (easy).
3. Pull electric leads from 2 solenoids (easy).
4. Remove 2 long screws holding upper painted structure (easy).
5. Remove 2 screws holding valve in place (easy).
6. Tilt and slide the valve loose and pull it out (easy).
7. Replace valve and reverse steps 6-1.

n.b. no inside water tubes; water drips straight into tub

Also, an hour should be enough. I spent more time than needed guessing, dealing with a few issues, opening the machine again, starting over, etc.

ps. I guessed at the age.

1) Unplug washer
2) Remove water supply hoses
3) Remove drain hose
4) Tilt washer forward
5) Remove 4 bolts covering the motor assembly to access belt.
6) Remove old belt by turning it off the pullies.
7) The new belt needed to be stretched by attaching one end of the belt to one of the pullies using a zip tie. I did this by drilling a small hole in the larger pulley, large enough to allow the zip tie to pass through.
8) After tightening the zip tie to the belt, slowly turn the larger pulley to stretch the belt on to the smaller pulley.
9) Make sure belt is properly seated on both pullies.
10) Reinstall the cover.
11) Reattach drain hose and supply hoses.
12) Plug washer back in.

looked up part not exactly easy. that was the hard part. it was delivered next day and just had to pop into place extremely easy instalation

Disconnect water lines.
Remove top control panel.
Remove 2 screws & disconnect wires & replace old for new

Lift the cover, undo too screws, Slide out broken part, slide in new part put in the screws and close the lid.A piece of cake.

Thank you for the super fast service on Christmas eve no less!

Took top of the washer then took one rod off at a time and replace with the new one, the back two are a little bit harder to do but it works great now.

Follow the super simple, precise instructions and it is very easy. Only harder part was unclipping the front of the lid.

>Change 4 rod & spring, (2 red, 2 blue) and
>LEVEL THE WASHER
(this was the initial cause of the failure!)
>clean tub

I watched a video on a few times that PartSelect sent me about how to make the switch from the broken lock set to the new one. And it really went just as the video showed. So far things are working.

Put the parts in, turned washer on.....lid lock still blinks, will not operate. Suggest the control board that sends the signal to the solenoid lid lock switch is defective. Buying a new washer, scrapping this one.

We changed the circuit board once, and the door latch mechanism twice because we ordered a faulty part. Then we had to hire a service man to program the circuit board, and to inform us that the door latch mechanism was faulty.

Watch a YouTube video on how to fix it. Video was really easy to follow

Remove old pump install new one. Three bolts and an electrical connection

Unplugged the machine, pulled it away from the wall, didn’t have to disconnect water lines, set the parts out on the counter as I went over the instructions a couple of times, followed the directions, plugged it back in, worked perfectly again.

Unpluged the washer first got as much water out of the drum as possible the leaned the washer over forward and let it rest against something removed hose clamp from pump side and removed the drain hose from pump remove plastic cover and unplug pump push tab and pull remove bolts from pump remove pump install all components in reverse be sure to replace pump to drum seal as well