GT1928PAHW Maytag Refrigerator - Instructions

The replacement handles were not exactly the same size as the old ones and the shape is different. One of the screws was stripped and wouldn't come out. I eventually broke off the handle and used a pliers to remove the screw. I had to use a heat gun to straighten the lower handle and stretch it to fit the mounting holes.

PartSelect handled their end well but the manufacturer has some work to do. I have several photos that will illustrate the problems.

Instructions were great five minutes to remove and replace fan....Thank You............ saved big money

Popped rail off and replaced with new one. Video showed how to do it. A bit tight to remove and just needed a little strength and patience.

installed new part easy

I did not do the repair yet, there is no schematic on how to route the hose; also no description of how to do the routing/connections.

I unscrewed the support and replaced it with one that I ordered. It was fast and easy.

Lined up slots pushed down snapped in; done

I first removed the drawer and then removed the shelf to which the drawer guide is mounted. Removing the drawer guide from the shelf was the hardest part - it was quite tight. I used a piece of wood and a light tap from a hammer to get it free. I had to reuse the roller from the old drawer glide (one screw). I snapped the new glide onto the shelf and I was in business. The best part was that the part arrived the day after ordering it - though I didn't request overnight delivery and the repair took less than 10 minutes.

Disconncted power, pulled plug on disconnect, loosened 3 ice maker attach screws, removed ice maker. carefully removed old broken part, to understand reasembly. Reinstalled new water fill & bearing part.. hung icemaker and tightened attach screws. Reattached electrical plug.. turned on power, it all worked. .took about 45 min to remove, 15 min to reinstall. Right tools needed re disassembly AND ASSEMBLY

Removed old ejector arm and installed new part.

I removed the ice catcher from the excellent packaging, rinsed it, and placed it on the counter next to the fridge. I opened the door the the freezer and placed the ice catcher under the icemaker. I lowered the arm on the icemaker and closed the door to the freezer. Then I opened the door to fridge, took out a Guinness, popped the top, and sat down to savor my success.

ordered a new shut-off valve. arrived in 5 days. installation had to wait a couple more day for i had to order a new compression nut. the reason i had to order a new nut was because the original nut was made of teflon and stripped easily when i tightened it to make a leak proof.joint. the new nut arrived in two days and was installed readily being that it was made of brass and consequently did not strip when i tightened to make a drip proof joint. finished in approximately twenty minutes' the video that this site has on the internet was of great value.

Replaced with new rail & popped it into place

I removed the old one and replaced with the new one. The right side one was quite easy whereas the left one took a longer time.

I had a heck of a time getting the broken rail off the drawer. I had to pry quite a bit with a screwdriver to get it to slide off. Other than that, it was like falling off a log.