GSL25IGXJLS General Electric Refrigerator - Parts

This evaporator fan blade is for your refrigerator, and it circulates air so that the temperature of the fridge is regulated. This model has 3 blades, and is a little more than 4 inches in diameter. It is made of white plastic and is sold individually. If your refrigerator is noisy and you hear a clicking sound, it is a good indication th...Read moreat the evaporator fan blade is warped or damaged. If the fridge or freezer sections become too warm, the fan could be to blame as well.

Coarse thread

This part connects the filter to the water lines. ***NOTE: Filter is NOT included.

Sold Individually.

This is a replacement fill tube and grommet assembly for your refrigerator. This part acts your water line to your ice maker. If you’re noticing water in the back of the refrigerator or any kind of leak, or if your ice bucket isn’t filling up with as much ice, you may need to change out the fill tube and grommet assembly. When you purchas...Read moree this part, you get the water line, as well as the fill tube and grommet. This is an OEM part sourced directly from the manufacturer.

This part is a replacement dispenser grille tray for your refrigerator. It is sold individually and is an OEM part from the manufacturer. This dispenser grille tray sits below the ice and water dispenser, and collects any spills. If your dispenser grille tray is broken or missing, this is the part that replaces it. This part is made of black plastic and is approximately 7 inches wide.

Sold individually.

Sold individually. This is used in refrigerator to store vegetable and fruits at an optimal temperature

This crank door recess is supplied directly from the original equipment manufacturer. The plastic part is fastened behind the interface dispenser assembly in the freezer door. Activated by the dispenser solenoid, this part regulates the opening and closing of the ice chute door. A screwdriver is needed for the repair. The crank door recess is sold individually.

This part helps to contain parts for the ice and water dispenser. The overlay and dispenser board is attached on the front of the housing shield.