GSC3500D35BB General Electric Dishwasher - Instructions

Ordered pump mechanism and replaced defective pump. A very easy replacement

replaced new wheels

There is nothing to tell I order send to location and their maintenance installs

Popped in the part

i needed new rollers and inserts to keep wheels on now its like new when i pull out bottom basket

so easy! Ordered the rollers and clips ... popped them on and done!!!

removed the rack and snapped the 4 week/axle assemblies on rack by hand pressure returned rack to track.

Removal of the old end cap required pliers. Not too difficult. The new end cap simply snapped into place. Both end caps on the two rack slides replaced in less than five minutes.

I put the new cap in. POC.

Removed the broken items and clicked the new ones in place utilizing a pliers

The end cap snapped into place perfectly without any problems and the rack works like new again. This is the second time I have used PartSelect.com and I am very satisfied with how fast I recieve the product and the easy of finding what I need. I would recommend them to anyone!

I opened the dishwasher, rolled out the defective/rusty Dishrack, removed it from the dishwasher and replaced it with the new Lower Dishwasher Dishrack.

Before attempting this repair, remember to remove any dishes from the lower Dishwasher Dishrack.

Simply replace wheel

All I had to do was slide the rack forward slightly, reach back to the end of the rack and snap the end cap into place. It helped to have someone there to balance the rack while I was replacing the cap.

First, remove the bottom front covers (two parts four screws). Second, remove the two screws at the top that secure the dishwasher to the counter. Third, gently pull away the dishwasher from underneath the counter just far enough to see and be able to remove the door spring(s) - one on each side. Fourth, remove the existing hinge arm link(s) if not already broken off, replace with the new one(s). Note that the door hinge goes on the door (front) side of the spring and the other side fits into a groove on the door arm - the other end of the spring attaches to one of the 3 available holes on the frame at the bottom. It would be a good idea to replace the hinge arm links on both sides even if only one is broken. Make sure that the door has the right tension (each spring can be hooked in 1 of 3 holes to adjust the tension). Then gently push the dishwasher back under the counter. Finally, replace the screws under the counter and replace the covers on the bottom front. All of this should take no more than 15-20 minutes. This was an easy job!