GS2788GKHQ Maytag Refrigerator - Instructions

Removed two screws from front cover,unpluged circuit board. Removed two more screws and cliped the door in place.

I pulled the drive ring off of the icemaker and replaced it with the new part. Saved a $150 service call plus cost of part. It cost me a little over $11.00 and a repairman probably would have charged $30.

Popped out broken switch with blunt flat edged instrument. Disconnected switch from unit . Plugged new piece in and reinserted into side panel of refrigerator. Very easy.

removed 4 screws, reeplaced broken ice door,
replaced 4 screws. Easy job with your site diagrams.

Removed by hand the old water filter and installed the new one.

Located the filter, removed the filter, installed the new one, reset the filter light on the front of the water discharge, and all is good.

Took door off refrigerator and removed worn parts and replaced the aforementioned parts, which took only a few minutes.

All work was done by hand. I removed the cover plate, unscrewed the existing water filter and screwed in the new one. I returned the cover plate to its original position and bled the air out of the line by running the water dispenser for a few minutes. It could no have been easier.

Remove (slide forward) the ice dispenser drain pad from the bottom of the ice dispenser assembly on front of the freezer door. Removing two screws (star head) at the bottom allows the ice dispenser cover to be removed. Remove 3 screws holding the ice dispenser assembly to the freezer door to gain access to the flapper. Remove and replace the flapper and reverse the steps to reassmble.

repair&parts instalation was easy but troubleshutting difficult.

I followed the video of your repair man. Made it very easy.Thanks.

Removed old ejector arm and installed new part.

Removed all shelves first. Cleaned inside of door prior to removing screws that hold the gasket/seal in place. Used DC drill with nut driver to remove all screws. Placed inner door liner on floor and replaced seal. Held door up with foot and started two screws at the top to hold door in placed. Worked way from top to bottom on both sides installing the screws. The two screws at the corners where the most difficult. Took less than an hour.

Disconncted power, pulled plug on disconnect, loosened 3 ice maker attach screws, removed ice maker. carefully removed old broken part, to understand reasembly. Reinstalled new water fill & bearing part.. hung icemaker and tightened attach screws. Reattached electrical plug.. turned on power, it all worked. .took about 45 min to remove, 15 min to reinstall. Right tools needed re disassembly AND ASSEMBLY

Emptied the door by taking out all the shelves with their contents. Removed the upper door closer works. Removed the door by lifting up and away from the main box. Layed the door on its side. Took out the old lower hinge pin and door closer with cup. Put in the new lower hinge pin and door closer with cup. Applied sewing machine gear grease to the 2 pieces where they work together. Lifted the door and placed the lower hinge pin into the door closer with cup. Replaced the upper door closer works.