My Orders
GRF218JSTA (ASTCLGA) LG Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The LH top door latch broke.
At first, ordered only a latch only to discover the mounting strip had instead failed. Ordering parts wasn't difficult although the parts catalog graphic leaves a lot to desire. Once I figured out how to remove the strip (had to remove the seal first and no instructions existed), it was easy to snap out the old and snap in the new part. T
... Read more
his sure beat the cost of paying a repairman. However I fear than most homeowners that aren't mechanically inclined wouldnt have been successful because of no instructions and the parts catalog that had poor detail and a very small size.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Lights Stayed on Melted Light cover
Replaces door switches - removed screw from door hinge cover, lifted cover and removed switch. Plugged in new switch and reversed process. Removed screws from light bracket. Attached new frame to slots in roof and used screws to attach. Clipped on light cover.
Other Parts Used:
Was this helpful?
Thank you for voting!
plastic center support (cover, tv) broke in center (2nd time in two years) :-(
The most time-consuming part is unloading the fridge so you can make the repair, and putting it all back in! Plus you clean everything (glass cover, etc) while it's out. The repair itself probably only took 25 minutes at most. You have to unscrew 4 screws to detach the center metal rails, then snap out the rails. Snapping them into the ne
... Read more
w cover must be done carefully so as not to break off the tabs on the plastic part you're replacing. It requires a little hand strength (I have arthritis in my hands, so my husband did this part). Then put everything back together and restock the fridge.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
the lights inside the frig weren't shutting off
the lights melted the lamp case and cover. I determined it was the switch ,but there was 2 of them . I replaced both . I used a screw driver to pry the covers off the switches which are on the top of the unit .Then I press the tabs on the switch and pulled it out. Slip the wire connect off. slip the wire connect on new switch press it in
... Read more
till the tabs snap in ,put covers back on. the lamp base and cover had two screws holding them, pull the screws slip the old melted base and cover. snap the new base and cover in and put the screws in done!
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Lights in upper refrigerator would not turn off with doors closed
replaced melted light covers, replaced switches, and found another problem with power circuit board relay, on order now!!
Other Parts Used:
Was this helpful?
Thank you for voting!