GPS01Z Makita Circular Saw - Parts

This is an authentic replacement part sourced directly from the manufacturer. The screw is commonly found in Makita circular saws, hypoid saws, and band saws. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer ...Read moreto the parts diagram to be sure of ordering the correct part. This item is available as an individual replacement part.

This replacement ball bearing is designed for power tools to reduce friction and support smooth, reliable rotation of internal components. Built for durability and precise fit, it helps restore proper motor and shaft operation when an original bearing becomes worn or noisy. It’s a practical maintenance replacement for maintaining consistent performance and extending the service life of power equipment.

This replacement ball bearing is an authentic Makita item. It is supplied directly from original equipment manufacturer for use with angle grinders. Please check diagrams for proper application of this item. The bearing is specially designed to reduce friction between rotating parts. Over time it will wear out and will need to be replaced...Read more. This is a sealed metal bearing and it is sold individually. Included in part number 515616-3

This is an authentic Makita replacement part manufactured for use with angle grinders and circular saws. The sealed bearing is used to reduce friction between a rotating shaft and fixed housing or assembly. This bearing is often used to allow the spindle to rotate inside the gear box, but may have other uses. Please see model diagram for part location and usage. This bearing is sold individually.

This is an authentic part made by original manufacturer. This bearing is compatible with various Makita power tools. A bearing serves to separate and buffer moving parts. It also keeps the moving parts in position while still allowing them to move/turn as needed. As a high-wear part, bearings are often replaced. This item sold individually. Washers and retainers sold separately.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling...Read more> - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression - O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening - O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking - O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.

Read less