GLDA696F00SS General Electric Dishwasher - Instructions

We ordered a whole new set for the lower rack and even though they were smaller than the original ones, we replaced them all and now the rack slides in and out of the dishwasher with ease!

Pulled dishwasher partly out from cabinet. Removed door after disconnecting springs. Removed old gasket easily. The new gasket was the correct part but would not slip into the place of the original. The door sheet metal was crimped onto the original gasket at the factory with some kind of tool to hold it securely. Had to spread the s ... Read more heet metal with a screwdriver to get the new gasket in place and used silicone seal to keep in position. Re-assembled the door after the silicone seal was dry and replaced dishwasher into the cabinet. So far it is working fine! Overall this gasket was not easy to change.

I pulled the dishwasher out, and discovered that the translucent pipe leading up the back of the machine was leaking at the point at which it fed into the middle tray.

I

put them on

A couple of lower rack wheels had fallen off, making it extremely difficult to roll the rack in and out. Putting on the new wheels was just a matter of popping them on and giving a sturdy push until they "clicked." Everything works perfectly now.

Remove and replace broken wheels by hand, simple.

Remove the 2 mounting screws holding the dishwasher to the counter top. Pull forwards a few inches.. make sure you have slack for power and water. Attach bottom of spring and with a pair of pliers stretch the spring and attach to top.

the repair was not the issue: finding the proper part was. the part listed by Frigidaire is not correct but with the help of your phone service associates and the east to navigate web site, I was able to locate the parts. thank you for everything....all in all, the experience was a good one.

Popped the old ones off and inserted the new ones. Though they are smaller the stud is fixed and not likely to separate.Works like a charm.Would shop here again

knocked the broken piece off and snapped the new wheels on - easy breezy.

Just popped the old wheels off with small tack hammer very easy to get off and pop back on in a couple minutes..

Snapped on new spray arm...in less than 5 minutes.

Removed old roller with pilers and pop in New roller really easy very happy partselect had right rollers it made it easy

Pulled original wheels and studs off. The snapped the new on to the lower rack. Swapped out the silverware basket. It was so easy women and children could do it! ;)

Just tool out the old micro filter and put in the new filter.