GH4155XPB0 Whirlpool Microwave - Instructions

Removed screws holding tabs from broken vent grill to microwave frame.

Carefully snapped new grill vent into slots on top of microwave and slid tabs into slots on top of the frame.

Replaced the two screws in the tabs.

Finished

We visited our daughter and son-in-law for Thanksgiving. They asked if I could fasten it so it would stop sagging onto the microwave door. As I looked, I found the screw fasteners were both broken out and the grill was just resting in place. While Thanksgiving dinner was being completed I looked online, found the replacement part and o ... Read more rdered it. The amazing delivery... Ordered on Thursday and delivered on Saturday. It only took a couple of minutes to get the step stool and screwdriver. Then I completed installing the replacement grill.

Unscrewed the remaining (2) screws that held the vent in place, placed the new grill in the tab loctators, and screwed it into place. Done...in less than 10 minutes. It took me 15 minutes to find my wife to show her what a nice job I did.

took old vent grill and tabs off using phillip screwdriver. started putting new grill on and it wouldnt go on. got to looking and there are two more screws that you have to loosen up so the grill will go into place these two screws are between the two tabs at each end. caution do not over tighten the screws it will break the tabs. overall ... Read more easy to install.

Removed the screws from the damaged sections and replaced the new vent grille. Less than 5 minute fix, and saved me over a 100 dollars according to the quote I got. Thanks

Take out the screws, broken pieces of clip, then put in the new vent grill, replace the screws. Done!

Replaced vent with 2 screws. Very easy.

All I had to do was open the microwave door and place the turntable on the designated grooves, wha lah it fit. I am now back in business. Thanks to partselect, I found my replacement, ordered and it was shipped in no time.

put the turntable in and had a Rum and Coke to celebrate. Your service was GREATTTTTT...

I remove the old broken Grill Vent by loosing two screws and just put the new one and adjusted with the same two screws.

I simply removed the original 2 screws for the old grill, attached the new grill, fastened it with the original screws & It fit perfectly in less than 5 minutes time.

Replaced it with a new vent grill simply by screwing in on. It works and looks great.

I was in a panic as no one in our twon had this part. I found PartSelect online and ordered the part. I ordered this part at 4PM and the next day at 2PM the part was at my house. My husband spent 30 seconds screwing it back on and it looks like new. I can't say enough wonderful things about your Company and Customer Service!!! You're ... Read more the BEST!!!

First remove two screws on top of microwave. Pull off old vent grill. Finally line up new vent grill (bottom edge first) then snap into place. Replace two screws on top of microwave.

This was a piece of cake! Less than 48 hours to get the part and 3 minutes to find and return the screwdriver and 3 to make the repair! I removed two screws, the old grill and then set the new grill in place and rescrewed the screws.