FS6500AG (Type 1) Black and Decker Angle Grinder - Parts

This is an original Black and Decker replacement part manufactured for use with grinders. This special spanner wrench is used to tighten and loosen the outer flange that secures the grinding disc. The wrench is available as an individual replacement part, please see model diagram for additional parts.

This is a Genuine Manufacturer Sourced replacement part used on Dewalt Grinders. This is a Carbon Brush with Lead Wire attached which is Sold Individually. Please note Brush Holder and Spring are Sold Separately. Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meani...Read moreng that through friction and use they will gradually wear away, they will eventually require replacement. It is recommended to replace both brushes at the same time. You would need a Screwdriver and Pliers to complete this job.

This is an original DeWALT replacement part. The flange is designed by the manufacturer for use in grinders. This part is made of metal, and is used to secure the gear case cover to the guard. You will require a screwdriver when replacing this item. This part is sold individually.

This replacement bearing is an authentic component which is supplied directly from the original equipment manufacturer for use with Black and Decker and Dewalt sanders and angle grinders. Bearings are used to reduce friction between rotating parts, please make sure to check appropriate diagrams of your unit for the correct location and us...Read moree of this hardware. Over time bearings tend to wear out and may begin to fail eventually requiring replacement to maintain peak performance. This part is made of high-quality metal and it is sold individually.