FS210LS (Type 1) Black and Decker Table Saw - Parts

This is an original Delta replacement part manufactured for use with drill presses and table saws. The special hex nut has multiple applications depending on the model drill press or table saw. This hex nut is sold as an individual replacement part, please see model diagram for part location and usage.

This is an OEM replacement part sourced directly from the manufacturer, sold individually. Snaps onto the bottom of the compatible power tools listed below. Four are needed for a complete replacement. No tools required for repair.

Included in part number 1342434

This is an OEM part sourced directly from the manufacturer. The cap screw is commonly found in power tools from Delta and Black & Decker, such as table saws, wood lathes, sanders, and drill presses. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are diffe...Read morerent screws used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The cap screw is available as an individual replacement part.

This item is available as an individual replacement part. The roll pin attaches to the guard and is made of metal. If this item becomes bent or broken it will need to be replaced and may require a set of pliers during the installation. This is an OEM part directly sourced from the manufacturer for use in saws, drills, jointers, and sanders made by Delta, Porter Cable, and Black & Decker.

This is a genuine replacement part sourced directly from the manufacturer. the nut is commonly found in table saws, router/shapers, jointers, and bench saws from Delta and Black & Decker. This part is made of metal, and may be found in various locations in the machine, depending on model. Please refer to the parts diagram to be sure of...Read more ordering the correct part. This item is sold as an individual replacement part.

Repeated breaker trips can be caused by a worn reset switch, but they may also warn of a motor fault or heavy load. The switch protects the tool by stopping current during an overload or short circuit. First check for jammed parts, dull blades, damaged wiring, poor airflow, and an undersized extension cord. Match the replacement to the fu...Read morell model and correct current rating. Disconnect the power cord before opening the housing, label each wire, and cover all terminals fully. Do not increase the breaker size or defeat this safety device.