FPCE19TFH0 Frigidaire Refrigerator - Instructions

Removed two screws to get to defrost time pull panel down remove two screws holding time and reinstall

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

Removed front low grill, removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the wires. Reversed process to install new timer.

Cleaned insert hole, did a dry-run, then pressed everything permanently in place.

I flew up to Sacramento to help my Aunt with chores around her home & saw an end cap was missing in her refrigerator so I ordered the part from you kind folks & had it sent to her I think she figured it out & is very happy .

took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .

Removed broken and installed nw part.

Just removed the two screws and unpluged it.
Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator.
Thanks for the fast delevery. Will do busness with you in the future.

order part and relaced bar

the parts fit good but tight. I needed to tap them in place and everything worked good. Your shipping is very fast and you had the parts!!!!!

Website was great!

The defrost timer was right in front. 2 minutes and a screwdriver and I had it replaced.

To replace the thermostat, I had to take out the back panel, defrost it and then install the new part. the only problem was that the heatshrink tubing they sent was too large. Otherwise, it worked great.

This past February 6th, my wife and baby son were in a car accident. Friends were generous and brought food for my family during the height of our crisis time. Our refrigerator was very full and the bar across the door shelf got pushed in and the end caps broke. We ordered the end caps (with the excellent help of Susan M. in customer service) and recieved the parts the next day. I fitted the parts on to the end of the bar and firmly snapped them into place in the refrigerator door. Done! It was that simple. The hardest part was getting both the left and right part, and Susan M. wen WAY out of her way to help us in our time of need. It may sound like a small thing, but it was one more problem during a time of significant family stress and hardship and it was one of the very easiest to fix and it was all done very very quickly. Thank you PartSelect and thank you Susan M. You were our angel in a time of need.

The door shelves in the freezer door of my Frigidaire refrigerator were broken, rendering the shelves useless. I ordered four (4) end caps from PartSelect. The end caps arrived in about five days. I attached the caps to the ends of the door shelves and popped them into the slots on the door. It was a very easy repair!.

Slipped out the end caps with the broken prongs from the front rack and slipped in the new end caps. (3 mins.)

Put new end caps on door bar..put soap around door slots diped end caps in boiing water for 20-30 seconds and snapped in place

I HAVE SENT IN TWO STORIES I"M DONE OK
BUT THANKS FOR GREAT SERVICE

Thanks Steve 10-3-09