FFU14F5HWN Frigidaire Freezer - Instructions

Unplug freezer let stand all night to defrost. Remove the tray cover which is located on the upper back area inside the freezer.( 3 twist fittings remove it ). Remove the upper stainless steel panel which is secured with 6 screws. This will drop down exposing the condenser. Note all the wires and fan will stay attached to the stainless steel panel, this panel will drop down no need to unplug anything. On the left upper side next to the condenser you will see the thermostat. Two color coded wires. Remove the thermostat and install the new one at the same location.

Pulled the existing EZ-Set Control 115V off and plugged the new one in. Very simple.

unpluged old part and replaced with the new part

inserted key and turned

The repair was a snap. I popped the old control panel out and snapped in the new one. PartSelect delivered the part in two days.

on the internet i checked with crosley parts trying to get an idea what the problem could be. i went to trouble shooting and after discribing the problem i was not at all surprised to see that there was only one sulution. to replace the control unit on the outside of the door.I ordered a new one and when it arrived i installed it and the freezed started working as it should again.

Removed old gasket by backing out screws around inner door panel. I did not remove the screws just loosened in order to remove old gasket. Starting from the top of the inner door panel I set the old gasket and squared off. Tightened top screws and worked the gasket in on the sides and tightened several of the screws on the sides then set the bottom of gasket in the door. Inserting the gasket in the bottom was the hardest part of the job. The overall job took less time than expected.