F101 Jenn-Air Range - Instructions

Simple repair. Unplugged element cart. and replaced.

Truned off power at circuit breaker box. Removed two screws to access the control panel wiring. Removed several connections to allow to pull wiring harness out for access. Removed lock nuts with combination of needle nose pliers and box wrenches. (it was difficult to find a size fit since nuts were distorted. Pulled old switch out. Inserted new one and new lock nuts. Reconnected loose wires and replaced housing. Turned on power and tested. All was well.

When burner insert arrived just plugged in. Piece of cake !

I simply removed the old cartridge by lifting it up and pulling the plug end out. I slid the new coil cartridge with the plug end in its place. The grill replacement was similar. Remove the grll grates, pull out the burner element from its plug position, remove the grill rocks and insert the new coil cartridge in its place. No tools or special skills required. It's like I now have a new cook top.

Just unplug the old broken cartridge and plug in the new one. It was very easy. Took 5 minutes.

Unplugged the old element and plugged in the new one.

The best part was it arrived less then 24 hours after I ordered it. Unbelievable, thank you.

Ordered new one, it came, and I put it on. The hard part was finding the model number,

Just replaced old with new, it plugs in same as old.

I also sprayed them 3-times with a clear coat before installing. The clear coat I purchased at WalMart once I noticed it claimed to be safe for plastic. Avoid a clear lacquer based product.

Removed and replaced infinite switch ; removed and replaced both cartridge so that they matched

manual instructions were included in the email notification re' shipping confirmation

Remarkably easy. We had purchased a Jenn-Air with 2 burners and a grill. We found we rarely used the grill feature. We needed more burners. We looked several years ago but it was quite expensive to replace so we suffered through it. I decided I had to find the replacement part or purchase a new stove. I found your website and was shocked to see you carried what I needed. The new part was half as much as we previously priced it for. So, we ordered it and it worked immediately. Thank you so much. Saved me from buying a new stove. Linda

My old burners pluged in. I pulled out the old burners unpacked the the new burners pluged them in. I turned on the new burners and tested themand they worked!!

First turn the power to the cooktop/fan switch panel off. Next remove the knobs used to adjust the temp of the cooking burners. Next remove the vent grill cover of the cooktop. Remove the two screws on the end of the box which houses the fan switch and burner controls. Slide box back and lift the box up. This exposes the fan swithch and burner control wiring. Remove the two wires connected to the fan switch. Remove the two self-locking washers from the two posts which hold the fan switch in place. A screwdriver works well to pry these off. Slide the fan switch assembly out. Slide the new fan switch in place over the two posts (one on each end) to align the switch. Put the self-locking washers which are packaged with the new fan switch on the posts. These can be difficult and a deep-set socket which is slightly smaller that the washers can be used to push them on. Next put the wires to the fan switch assembly on. At this point I temporarily turned the power on to test the fan switch, being careful not to touch any of the wires. If the fan operates properly, turn the power back off. Then replace the box which holds the fan switch and burner controls. Replace the two screws which hold the box in place. Replace the vent grill cover and the temp control knob tops. Turn on the power.

Pulled off old knob, then pressed on the new one.
It was very easy, and the part was the correct one.

First remove front oven door panel screws, then attach with 2 screws new handle part from inside door panel, reattach outer screws and job complete.