EOF9-77*579AW Hardwick Range - Instructions

I just removed the lamp retainer plate and glass cover, inserted the new gasket, and screwed everything back in place. Simple as that. I was enormously pleased that the part arrived so quickly -- just in time for me to cook my Thanksgiving turkey and use the self-cleaning feature.

This repair was very simple.
First I UNPLUGGED the stove.
Then I removed the 6 screws on the top portion of the back panel.
Then I removed the knobs from the front of the stove.
Then I removed the 2 screws holding on the front glass covering the clock/timer.
I then drew a diagram of the wire colors and the corresponding numbers on the old timer block. Then I removed the 6 wires from the old timer.
I then pushed in on the 4 black holders that secure the clock/timer to the chassis. The clock/timer pushes out from the rear to the front.
Going back together, just push the new clock/timer into the hole until the holders snap in place.
I then found the corresponding numbers on the new clock/timer block and put on the respective wire colors.
I then put the front glass back on, then the knobs, then the back panel.
Plug it in and you are golden. It couldn't be easier. It took all of about 15 minutes.

Removed burnt bulb. On replacing the bulb I glued the bracket, retainer gasket and bulb cover together- I used only a small amount of glue-just enough to hold the three items together. You need to do this since the three items slip in your hand while you attempt to screw the bracket to the oven wall. Need my help, email me @ Lexidog999@tx.rr.com

Removed what was left of the original clips. Pressed in the new clips and snapped in the themostat blub

placed knob on clock shaft with my fingers

1. Unscrewed glass cover on bulb
2. Removed old bulb
3. Screwed in new bulb
4. Replaced glass cover
5. Mixed drink & baked cupcakes

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

Removed old element and element gasket. Replaced both by alining gasket with element and screwing in retaining screws. Jod completed.

Removed the old timer and installed the new one without any problems.

snaped them into oven cavity attached temp bulb job complete

My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on.

very easy

ordered new broiler pan

I pulled down the wire around the glass cover. . . Released on end of the wire from its holder being careful to not let the glass cover drop. Unscrewed the bulb and replaced with replacement. Easy, easy.

Ordered and received the terminal block. Installed it along with a new 220V power cord and the appropriate insulator . Ensured the terminals were tight with a nut driver. Reinstalled cover. Then, using the control panel, I did a function check on all the heating elements, clock, oven light, to satisfy all operational requirements. All checked good! And, I was relieved that the control panel had not been shorted out as the terminal block was due to a loose connection. Easy fix.