EI30DS55JS2 Electrolux Range - Parts

This part is the igniter/orifice mounting screw for your cooktop or range. It is approximately ½ an inch in length and is made of metal. The mounting screw connects the orifice to the cooktop. If the orifice is loose, or the screw is missing, this is the part that will replace it. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.

This orifice is a replacement fuel-delivery component designed to regulate gas flow to a burner. It plays a critical role in maintaining proper flame size and efficiency and is commonly replaced when flow becomes restricted or uneven.

This gasket creates a tight seal between surfaces to prevent leaks, air loss, or temperature fluctuations. Maintaining a proper seal is essential for efficiency and performance, making replacement necessary when the gasket becomes worn, torn, or deformed.

Sold individually.

A cracked or warped burner cap can interfere with flame shape and cooking performance. This replacement sits on the burner head, helping distribute the flame evenly while protecting the openings below from spills. Check for food buildup, blocked ports, moisture, and incorrect cap placement before deciding a replacement is needed. Verify f...Read moreit using the complete appliance model because burner caps may look alike but differ in size or output. Turn every control off and wait until the cooktop is completely cool before installation. Place the clean, dry cap flat over the correct burner. Stop using the appliance if you smell unburned gas.

Sold individually.

The function of the ignitor in your range is to create the spark that ignites the gas on the burners. If your spark ignition system is not functioning properly, you may need to replace the ignitor. This part is approximately 3 inches in length. The ignitor is located in the rear of the range, so you will need to remove the back panel in o...Read morerder to access it for this repair. Before beginning this repair, be sure that the gas valve for the range is shut off. You should also disconnect the power source to the range before you begin.

As per the factory, the original part was 19 3/4 inches and the new substituted part is 16 1/4 inches. According to the factory, this part will still work with your appliance.

Sold individually.