Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The water inlet valve on the dishwasher leaked.
4 of 6 peoplefound this instruction helpful.
John from Andover, MN
Really Easy
15 - 30 mins
Screw drivers, Wrench set
The repair was very easy and straight forward. I removed the electrical wires, removed the two hose's and then removed the old valve from the dishwasher frame. To install the new valve, I just did everything in reverse. No problem and I saved about $80 for the repairman to come out and I am sure I would have paid more for the valve if
... Read morehe provided it.
Thank you.
Read less
Was this helpful?
Thank you for voting!
detergent dispenser was not closing and dishes were dirty
3 of 3 peoplefound this instruction helpful.
Harinder from CHESTERFIELD, NJ
Really Easy
15 - 30 mins
Pliers, Screw drivers
followed the video step by step which was very well expalined and was able to complete the install
Was this helpful?
Thank you for voting!
Missing wheels
4 of 6 peoplefound this instruction helpful.
Denise from PALERMO, ME
Really Easy
Less than 15 mins
The wheel kit came with axel's to support them. They snapped in place in seconds. No instructions provided, but installing method was obvious.
Was this helpful?
Thank you for voting!
The wheels on the lower rack of our dishwasher kept falling off.
4 of 6 peoplefound this instruction helpful.
Sharon from THE VILLAGES, FL
Really Easy
Less than 15 mins
Removed the lower rack. Took off the old wheels. Put the axles on the new wheels which took a little manpower, but became easier once you did a couple (there are 8 wheels). Then snapped the new wheels on the rack which was really simple. The new design is much improved to the old one. The wheels glide better, then they ever did. We'
... Read morere sorry we didn't think of this repair years ago and the cost was a fraction of the cost of a new dishwasher.
Read less
Was this helpful?
Thank you for voting!
Rinse cap was broken
3 of 3 peoplefound this instruction helpful.
DENNIS from MAUMEE, OH
Really Easy
Less than 15 mins
Pliers, Screw drivers
Watched online video, repaired myself in under 10 minutes. Easy fix with video instructions
Was this helpful?
Thank you for voting!
at start of the wash cycle did not take in any water
5 of 9 peoplefound this instruction helpful.
wojciech from bayonne, NJ
Really Easy
Less than 15 mins
Nutdriver, Screw drivers, Wrench set
very easy old part out new part in direct replacement, fit right in and it is working. Great deal and about half of the price than ge website. Thank you.
Was this helpful?
Thank you for voting!
Replaced dishwasher but had the wrong drain hose.
4 of 6 peoplefound this instruction helpful.
Victor from Phoenix, AZ
Really Easy
Less than 15 mins
Pliers, Screw drivers
Attached the drain hose to the dishwasher pump and to the sink pipes and I was done.
a couple of retaining ears were broken from the cover allowing the the switches and plunger to move out of place
3 of 4 peoplefound this instruction helpful.
charles from royal oak, MI
Easy
Less than 15 mins
Nutdriver
took screws from inside door panel and replaced the cover taking care not to allow plunger and spring to pop out put panel in place and screwed down
Was this helpful?
Thank you for voting!
Upper tray rollers broke
3 of 4 peoplefound this instruction helpful.
Marlene from Hopwood, PA
Really Easy
Less than 15 mins
Screw drivers
Three of the four roller of my upper shelf of my dishwasher had broken...I went on line and in ten minutes ordered my rollers....a few days later rollers came and within fifteen minutes my dishwasher was up and running.....thank you so much....I will absolutely use this site again for future repairs....Thanks again. Marlene Martin
Was this helpful?
Thank you for voting!
Water leak from inlet valve
3 of 4 peoplefound this instruction helpful.
Tony from Auburn, CA
Easy
15 - 30 mins
Nutdriver, Pliers, Wrench (Adjustable)
Had to pull the dishwasher from under the counter to access the water inlet valve. Disconnected the hoses from the inlet assembly. Removed the inlet assembly from the dishwasher frame. Installed the new assembly and reconnected the hoses. Plugged the dishwasher in, selected a cycle to run to check for leaks.
Was this helpful?
Thank you for voting!
Dishwasher would only 'partially' drain; dishes needed more rinsing.
3 of 4 peoplefound this instruction helpful.
James from SEDONA, AZ
Easy
1- 2 hours
Nutdriver, Screw drivers, Wrench (Adjustable)
Called repairman: announced that the drain pump was gone. Did not seem right. Went to the website. Found what I was looking for. 49% of the time it was a check-valve issue; only 26% of the time was the pump the problem. Took the unit from under the counter; got it on its side; removed the drain pump. Found my first check-valve, but thedi
... Read moreagram showed a second lower one toward the sump. Having located both and purchased two valves and and the lower holder piece, I was ready to finish the job. Quarter-inch nut driver and a screw driver and the valves were in and the drain pump re-installed. Most difficult in my case was getting the dw back into its spot and lashed down! Thanks for the good guidance!
See GE web site for repair instructions. Take out screws at top of door. Slide unit out there is a spring on each side of the door just look at the good one for details. Easy fix. About 30 minutes.
Was this helpful?
Thank you for voting!
Dishes were not drying inside the dishwasher after the dishwasher cycle completed
2 of 2 peoplefound this instruction helpful.
Christopher from GLEN ALLEN, VA
Easy
30 - 60 mins
Wrench (Adjustable)
The installation video that is on the website with the part is very helpful & easy to follow. The wires that attach to the heating element & the nuts that hold it in place are actually located a few inches off the ground so I didn't need to tip the machine over to pull them out & unscrew the nuts. All I had to do was unscrew the screws
... Read morethat hold the dishwasher in place under the counter next to the sink, pull it out & was able to reach the wires underneath it. The actual repair took me less than 30 minutes, I marked it as 30-60 because during the somehow the water line going to the dishwasher had come loose from under the sink (not at the dishwasher) & because of this I had to stop midway to deal with some loose water & tighten things back up. I would recommend following the video, there really isn't much more to add that would be helpful.
My Orders
