EDR648 Caloric Cooktop - Parts

This manufacturer-certified drip bowl is also known as a drip pan, and it is designed for use with cooktops and ranges. It sits below 8-inch burner elements and catches drips and spills from the cookware on the burner. The diameter of the drip bowl is approximately 10 inches. This replacement might appear slightly different, but it will f...Read moreit your appliance. You will need no tools to complete this repair. Simply remove the burner element, remove the old bowl, line up the hole on the new bowl with the terminal block and drop it into place. Make sure the bowl is flat before reinstalling the element. While you have the element out you should inspect the terminals for corrosion, damage, or discolouration. If you notice any of those things you should also replace the element and terminal block. You will need to replace your drip bowl if it is lost, damaged, or can no longer be cleaned. This replacement part is sold individually. To extend the life of your new drip bowl we recommend you clean it regularly with soap and water. We recommend only using the recommended drip bowl for your appliance; generic versions will not fit properly which could affect the performance of your elements and cause long-term damage.

This part has been substituted by the manufacturer and has a hole in the center. It no longer has a solid bottom.

This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw.

This screw is sold individually.

This large surface burner is 2100W.

This screw is sold individually.

This terminal block mounting bracket is a little over two inches long. It is made of metal.

Sold individually. This spade is used for either a ground contact or a power contact.

This filter assembly is just under eleven inches long and is not quite six inches wide. It is a metallic filter and it is used with some downdraft ranges.