My Orders
DWHD64EP Thermador Dishwasher - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Rinse aid dispenser lid would not stay closed
3 of 3 people
found this instruction helpful.
-
Sue E from CARMEL, IN
- Very Easy
- Less than 15 mins
-
Nutdriver
Use a screwdriver flat blade to pry up one edge of closed lid. Put one side of lid into hinge and snapped other side into place. Very easy.
Was this helpful?
Thank you for voting!
Lid for the streak treatment wouldn't stay shut.
3 of 3 people
found this instruction helpful.
-
Gary from NEW PARIS, IN
- Really Easy
- Less than 15 mins
Use screwdriver to gently wedge the side of the dispenser body apart enough to pop out the old kid, then insert the new kid in it's place.
Was this helpful?
Thank you for voting!
detergent dispenser on Bosch dishwasher was not staying closed
3 of 3 people
found this instruction helpful.
-
RAYMOND from WOODHAVEN, MI
- Really Easy
- 30 - 60 mins
My husband spent minimal time and maybe just screwdriver for repair of replacement part.
Your company was great to work with.
Thank you!
Your company was great to work with.
Thank you!
Was this helpful?
Thank you for voting!
I did not know how to reach the part to be replaced so I took the base off and everything became complicated as I had to put it back, lots of electrical wires, houses aso.
4 of 6 people
found this instruction helpful.
-
Razvan I from Incline Village, NV
- Difficult
- 1- 2 hours
-
Screw drivers
To replace the part per se was simple. To put everything back in place was more difficult as I took the base of the dishwasher off and a lor of other parts in order to reach for the drain pump. The irony was, after I took appart the base I fount a clip on the internet showing how to do that job and that was a very simple thing, couple of
... Read more
screws to take off the toe plate and the interior liner of the door, to create good access to the drain pump. Really a job of 10 minutes at the max.
Read less
Was this helpful?
Thank you for voting!
No water into dishwasher
3 of 3 people
found this instruction helpful.
-
Samuel from PORT ORCHARD, WA
- A Bit Difficult
- 1- 2 hours
-
Pliers, Screw drivers, Wrench (Adjustable)
Remove lower panel
TURN OFF POWER AT BREAKER
Remove water line
Remove the screws on bottom left of washer to remove solenoid valve
Pull out solenoid valve carefully there is a wire plugged into it, far enough to remove clamp on the hose
Remove valve far enough to disconnect wire
Order correct valve assembly ... Read more r />Reinstall in reverse order
TURN OFF POWER AT BREAKER
Remove water line
Remove the screws on bottom left of washer to remove solenoid valve
Pull out solenoid valve carefully there is a wire plugged into it, far enough to remove clamp on the hose
Remove valve far enough to disconnect wire
Order correct valve assembly ... Read more r />Reinstall in reverse order
Read less
Was this helpful?
Thank you for voting!
When I checked the drain filter to clean, I noticed the plastic supports were broken and the micro screen had collapsed.
3 of 4 people
found this instruction helpful.
-
C Loren from TWIN FALLS, ID
- Really Easy
- 15 - 30 mins
I took out the old filter and replaced it with the filter I had ordered. Very easy and not necessary to call a repairman.
Was this helpful?
Thank you for voting!
Overfill then no fill
2 of 2 people
found this instruction helpful.
-
Lawrence from FREDERICKSBRG, PA
- Easy
- 30 - 60 mins
-
Nutdriver, Pliers
Remove bottom kick plate and raise the feet up. Remove attachment from the top to counter. Slide out. Facing the unit, remove left hand side sheet metal cover. The unit is behind this cover. Unhook the hose on the lower end. Pop the new one in and hook it up!! Test on quick rinse and see results. If ok return to normal as disassembled. Ma
... Read more
ke sure to level the unit after tucking it back in. Enjoy!!
Read less
Was this helpful?
Thank you for voting!
Water leakage from the dishwasher; unknown source.
2 of 2 people
found this instruction helpful.
-
Bill from Seattle, WA
- Really Easy
- Less than 15 mins
Followed the video on your site and it was an easy install with no more leakage.
Was this helpful?
Thank you for voting!
Droning noise coming from the dishwasher
2 of 2 people
found this instruction helpful.
-
Terrance from Lake Stevens, WA
- Easy
- 1- 2 hours
First of all, I quessed at what was causing the droning noise. It seemed that it started when the d.w. was draining. I looked at various sites to try and figure out what was causing the noise but they all wanted money up front before they would discuss the problem. I gambled that it was the drain pump figuring that, oh well at least it's
... Read more
a part I won't have to replace in the future. I got lucky, the noise stopped with the part I bought. The only issues were the wiring harnesss wasn't the same as in the video I used. Overall, your service was very good. The thing I'm disappointed with is the fact that my expensive Bosch d.w. had to be repaired.
Read less
Was this helpful?
Thank you for voting!
Chronic water leakage
2 of 3 people
found this instruction helpful.
-
Callan from CHICAGO, IL
- Difficult
- More than 2 hours
-
Pliers, Screw drivers, Socket set
Replaced ‘sump’ housing , seal was leaking on it- replaced inop float on water level warning system switch, and switch itself as well- replaced drain pump motor attached to sump- replaced o-ring seal at water sprayer inlet valve- replaced water inlet plastic assemble on side of dishwasher- replaced drain hose out of sump assembly.
... Read more r />Used YouTube video to understand repair- this is an involved repair in time and complexity- dishwasher eventually gets turned upside down once removed and stripped down, to remove the white plastic water pan , which then allows access to the guts of all the above parts- some critical seals only come with new assemblies, so you are buying that new part to get a new seal and ensure no new leaks from what you took apart.
... Read more r />Used YouTube video to understand repair- this is an involved repair in time and complexity- dishwasher eventually gets turned upside down once removed and stripped down, to remove the white plastic water pan , which then allows access to the guts of all the above parts- some critical seals only come with new assemblies, so you are buying that new part to get a new seal and ensure no new leaks from what you took apart.
Read less
Was this helpful?
Thank you for voting!
Getting to the part at the bottom of the dishwasher was a little pain.
2 of 3 people
found this instruction helpful.
-
Travis from Hermon, NY
- Very Easy
- 15 - 30 mins
-
Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
Everything went great installing the new drain pump. Our dishwasher works like it’s brand new again. I would recommend part select to anyone that needs to repair their dishwasher parts or any applications parts.
Was this helpful?
Thank you for voting!
Missing/broken wheel on right side of lower dishwasher rack
2 of 3 people
found this instruction helpful.
-
Danette from SANTA FE, NM
- Very Easy
- Less than 15 mins
I snapped the part in and voila!
Was this helpful?
Thank you for voting!
Drain filter got old fell apart
1 person
found this instruction helpful.
-
Mary from HUNTINGTN STA, NY
- Really Easy
- 15 - 30 mins
Unscrewed the old piece screwed in the new
Was this helpful?
Thank you for voting!
Door would no latch
1 person
found this instruction helpful.
-
keith from POULSBO, WA
- Really Easy
- 15 - 30 mins
The perfect replacement part. Plug and play.
Was this helpful?
Thank you for voting!
Not getting water
1 person
found this instruction helpful.
-
Ranaye from BECKER, MN
- Very Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
shut off water, pull dishwasher out, took side insulation off, unhooked what was connected to the float switch and replaced the new with the old. Reconnected everything and put insulation back and wa-la , all done
Was this helpful?
Thank you for voting!