DWFP12231 (Type 0) DeWALT Nailer - Parts

This item has been OEM sourced to ensure a high level of quality. The o-ring is intended to be used with pneumatic nailers from Bostitch, Porter Cable, and DeWalt. The o-ring is used to seal the connection between the nose and the bottom of the cylinder. This item is sold as an individual replacement part.

This authentic item is supplied directly from the original equipment manufacturer for use with Bostitch, Porter Cable and DeWalt nailers and staplers. It is an identical replacement for a missing or a damaged screw that was installed on a new unit. Check the appropriate diagrams for your model for the exact location and the correct applic...Read moreation of this component. Keep in mind this high-quality screw is made of durable metal and is sold individually. A screwdriver will be needed to secure and remove it.

This replacement screw is a high quality item that has multiple uses depending on the model of your tool, please make sure to check appropriate diagrams for correct location and use of this hardware. It is a genuine screw that is sourced directly from original equipment manufacturer for use with nailers and staplers. Note this durable metal hex socket head screw is included per order.

The elastic stop nut attaches to the frame. It is made of metal and is sold individually. This is an authentic Bostitch, Porter Cable, and DeWALT replacement part that is sourced from the original manufacturer for use with staplers and nailers. A wrench may be needed during the replacement of this part. It will need to be replaced if it breaks.

This is an original Porter Cable replacement part. The end cap is designed by the manufacturer for use in nailers and staplers. This part is made of high-quality plastic, and is used to secure the rear of the frame assembly. This product is supplied as an individual replacement part.

This is an authentic OEM sourced replacement part designed for use with brad nailers. The piston/driver assembly is the part of the nail gun that drives the nail into the material that is being used. Drivers do have a tendency to bend or break if not used correctly or if you are driving nails into extra hard material. This assembly is ma...Read morede out of metal and it is sold individually. To help extend the life of a pneumatic tool use the specified oil in it daily 4-5 Drops will do every time you use it. To replace this part you would need a screwdriver • First you want to remove 4 screws from cap • Remove the cap • Remove driver, and take out piston ring and o-ring • Secure the o-ring and piston ring on new driver • Install new driver • Reattach the cap with the 4 screws