DWD450 (2) DeWALT Boring Machine - Parts

This screw is commonly used on a variety of power tools. It is a genuine OEM sourced replacement part. Please make sure to check appropriate diagrams for correct location and use of this screw. Includes one pan head screw per order. You will need a screwdriver to install or remove it.

It is a genuine manufacturer sourced replacement part designed for use with a variety of power tools. It is a standard screw that has multiple uses based on a tool. To ensure compatibility please make sure to check appropriate diagrams for correct location and use of this item. Includes one (1) metal screw per order. Requires a screwdriver for installation/removal.

This screw is an original part from DeWalt. The metal screw is often used to secure the brush door of several drills and grinders. This component is sold individually, and a screwdriver is required for the proper installation.

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with drills. The side handle is threaded and screws into the slot on the gearcase. This item does not require tools to install and is sold as an individual replacement part.

This replacement carbon brush is an authentic item. It is specially manufactured for DeWalt drills. Carbon brushes are a commonly replaced part on power tools. Due to normal use and friction brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type. This assembly includes one (1)...Read more carbon brush with a lead wire attached. Please note, the brush holder is sold separately. Replacing this carbon brush is a simple task that should only require a screwdriver. • Make sure the unit is unplugged • First remove housing screws • Remove the housing • Take out the old brush • Secure the new brush in place • Reassemble and test the tool

This needle bearing is open on one side and closed on the other. This genuine DeWalt replacement part is sold individually. • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. ...Read moreThis reduces wear on the tool, allowing it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

It is an authentic item that is supplied by original equipment manufacturer for use with Dewalt, Porter Cable and Black and Decker power tools. This replacement spring helps to provide tension for the carbon brush pushing it against the armature. Over time the spring may lose its tension or even break eventually requiring replacement. It is made of durable metal and it is sold individually.

This cord protector is a genuine DeWalt replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

This is a genuine manufacturer sourced replacement screw. It is commonly used with electric drills. This left hand threaded screw is specially designed to secure drill chuck to the spindle. It is made out of metal and it is sold individually. Requires a hex key/allen wrench to tighten/loosen this screw