DW968K-2 (Type 1) DeWALT Impact Driver - Parts

Included in part number 380264-09

This is an authentic DeWALT replacement part. The spring is commonly found in DeWALT power tools such as drills and screwdrivers. This is a metal part used to hold the shifter switch in place. This part is sold individually.

It is a genuine item that is supplied by the original manufacturer for use with DeWALT and Black and Decker power tools. This clutch is a special component that helps to engage the drive shaft. It provides an identical replacement for a damaged or a missing hardware that was installed on a new unit. Check the diagrams for your model for t...Read morehe exact location and the correct installation of this part. One durable metal clutch is included. You may need a screwdriver and a wrench set to perform this repair.

This is a genuine Dewalt replacement part designed for use with a variety of power tools. It is a standard hardware which has multiple applications based on your tools. This is a metal torx T-10 screw which is sold individually.

This is a genuine manufacturer-approved component which is designed for use with DeWALT and Black and Decker screwdrivers. The purpose of a spring is to apply tension on the guide in the clutch. Unfortunately, over time it may wear out, get damaged or simply lost eventually requiring a replacement. To ensure the exact location and the cor...Read morerect application of this hardware, refer to the diagrams of your model. One durable metal spring is included.

This brush kit is supplied directly from original equipment manufacturer. It is a genuine replacement item that is specially designed for use with drills/drivers. Carbon brushes are some of the most commonly replaced items. Due to normal use and friction brushes will gradually wear down requiring replacement. It is advised to replace both...Read more brushes at the same type. This set includes two (2) carbon brushes, two (2) metal brush holders with springs and two (2) lead wires. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • Remove the housing screws • Separate the housing halves • Disconnect lead wires • Take out old brushes and replace them with the new ones • Reassemble and test the tool