DW708 (Type 4) DeWALT Miter Saw - Parts

It is a genuine replacement screw which is supplied directly from the original equipment manufacturer, it is specially designed for DeWALT crosscut miter saws. Please refer to the appropriate diagrams of your model for the correct location and application of this hardware. It is a high-quality screw which is made of durable metal and is sold individually.

This is an authentic DeWALT replacement part. The plastic trigger is compatible with several crosscut miter saw devices. The trigger is designed to help the user move the circular saw table to a desired position. This part is sold individually. A screwdriver is needed to make the proper removal and replacement.

This is an original DeWalt replacement part manufactured for use with miter saws. This retaining ring is used with belt drive miter saws. The ring typically secures the bearing to pinion shaft which is driven by the belt and pulley. This retaining ring is sold individually, please see model diagram for additional parts of the blade drive assembly.

Genuine Dewalt replacement part, this item is sold as a kit. The 153755-01 includes both the upper and lower handle. The part is where the trigger switch fir the Miter Saws shown below is placed. This is also the handle that you raise and lower the blade with, and also pull to make a cut in the material you are cutting.

This is an authentic DeWalt replacement part, sourced from the original manufacturer for use with miter saws. The special retaining ring is commonly used to fasten the spring to the lock rod. This retaining ring is available as an individual replacement part, please see model diagram for associative parts.

This is an authentic manufacturer-sourced part which is specially designed for use with DeWALT crosscut miter saws. This fence adds height to the side, it also helps to assist with taller moldings and workpieces as well. Please make sure to refer to the owners manual and the appropriate diagrams of your model for the correct location and ...Read moreapplication of this component. This high-quality right fence is made of durable metal and is sold individually, keep in mind the hardware to secure it is sold separately.

This is an authentic manufacturer-supplied part which is designed for DeWALT miter saws. It is a special hardware which is utilized to provide a tight fit between connected components. Please make sure to refer to the appropriate diagrams for your model for the correct location and application of this thrust washer. This high-quality part is made of durable metal and is sold as an individual item.

This genuine Dewalt screw is a high quality item specially designed for use with miter saws. This special piece of hardware has a few different applications depending on your tool. Please make sure to check appropriate diagrams for correct location and applications of this item. Note, this part is sold individually. You will need a torx screwdriver or a flat-head screwdriver to install or remove this screw.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling...Read moreu> - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression - O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening - O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking - O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.

Read less