DW318K (2) DeWALT Jig Saw - Parts

This is an authentic OEM component from DeWalt. The ring is made for use with many jigsaw devices. The metal ring helps to secure the bell crank components, and is sold individually. Needle nose pliers are often used for the removal and installation.

It is a genuine manufacturer sourced replacement part designed for use with a variety of power tools. It is a standard screw that has multiple uses based on a tool. To ensure compatibility please make sure to check appropriate diagrams for correct location and use of this item. Includes one (1) metal screw per order. Requires a screwdriver for installation/removal.

This is a genuine DeWalt replacement power cord, specifically designed for use with double-insulated tools. Built for durability and safety, it features two wires and two prongs, eliminating the need for a ground wire. The cord measures 8 feet in length and uses 18-gauge wiring, offering a reliable connection and flexible reach for your p...Read moreower tool needs. It’s sold individually and is compatible with the models listed below. Installation requires careful attention: the new cord wires must be properly inserted into the wire terminals, and the cord should be routed correctly to avoid pinching when reassembling the tool’s case or plate. For best results, refer to your tool’s manual or consult a professional technician.

This is an authentic DeWALT and Black & Decker replacement part that is sourced from the original manufacturer for use with saws, grinders, jointers, nibblers, plate joiners, polishers, routers, sanders, and shears. The retaining ring attaches to the ball bearing and is made of metal. When replacing this item an allen wrench and a screwdr...Read moreiver might be required during the installation process. It will need to be replaced if it becomes bent or broken. This part is available as an individual replacement.

The rubber cup goes next to the brush spring. It is a genuine item that is supplied by the original equipment manufacturer for use with drills, grinders, jointers, polishers, routers, sanders, and saws made by DeWALT, Black & Decker, and Porter Cable. This is made out of rubber and is sold individually. It might require an allen wrench to replace this part if it becomes broken.

This is an authentic replacement part manufactured for use with jigsaws. The special yoke bar is commonly used to link the blade clamp and the main or drive gear. This yoke bar is available as an individual replacement part, please see model diagram for associative parts.

This replacement item is an authentic OEM sourced hardware that is specially produced for Dewalt and Black and Decker jig saws. This set screw is an important piece of blade clamp mechanism that secures the blade, for correct location and use of this hardware please make sure to check appropriate diagrams of your equipment. One durable metal hex socket head set screw is included per order.

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with shears, joiners, and grinders. The plastic case is used to house and protect the motor assembly and to link the gearcase. This item is available as an individual replacement part and both halves are included. A torx driver is needed to install this item.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.