DW294 (Type 1) DeWALT Impact Driver - Parts

This is an authentic replacement part manufactured for use with impact wrenches. The gear and pinion is used to drive the cam and gear, that spins the impactor and anvil. The pinion is in direct drive with the armature. The gear and pinion are one unit, and it is sold individually.

This is a genuine component which is sourced from the original manufacturer for use with DeWALT, Black and Decker and Porter Cable power tools. The special terminal is commonly used to link the wire from the cord to the switch. It provides an identical replacement for a missing or a faulty part that was installed on a new unit, please che...Read moreck the diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality terminal is made of durable metal and is sold individually.

This genuine DeWalt carbon brush comes with a wire lead enclosed in a rubber sheath for added protection and durability. It’s designed to fit a variety of tools—including drills, impact drivers, and impact wrenches—and helps keep your motor running smoothly. Since most tools use two brushes, it’s a good idea to inspect both and replace th...Read moreem at the same time. Carbon brushes are wear-and-tear parts that naturally wear down with use. When they do, your tool might lose power, run intermittently, or stop working altogether. Replacing the brushes can often fix these issues and restore full performance. This part is sourced directly from the manufacturer, so you can count on a proper fit. Be sure to check your tool’s manual to confirm compatibility before installing.

This is a genuine Dewalt replacement part, it is sold individually. The purpose of the Detent Pin is to secure sockets to the anvil on the Impact Wrench model numbers shown below. It is held in the anvil by use of a spring and pin.

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 18 Gauge • 8 Feet Long

It is an authentic item that is supplied by original equipment manufacturer for use with Dewalt, Porter Cable and Black and Decker power tools. This replacement spring helps to provide tension for the carbon brush pushing it against the armature. Over time the spring may lose its tension or even break eventually requiring replacement. It is made of durable metal and it is sold individually.

This is an original replacement part manufactured for use with electric power tools. The special sleeve is commonly used to provide spacing between the armature bearing and the motor housing. This sleeve is available as an individual replacement part, please see model diagram for associative parts.

It is a high-quality OEM part that is specially made for Porter Cable, Black and Decker and DeWALT power tools. The receptacle is designed to safely secure and connect a wire. It is an identical replacement for a faulty or a missing part that was installed on a new unit. To ensure the correct application, refer to the appropriate diagrams...Read more of your model. Note, this high-quality receptacle is made of durable metal and is sold individually. You will need a screwdriver to take the housing apart when replacing this component.

This is a genuine OEM sourced replacement part designed for use with a variety of power tools. Cord guards, also called cord protectors, are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. It is made out of rubber and it is sold individually.

Replace worn or missing hardware with this genuine manufacturer-sourced metal ball. Designed specifically for use with select DeWALT, Porter-Cable, and Black & Decker power tools, this high-quality component offers a precise fit and reliable performance. It serves as a direct replacement for the original part installed on new units, helpi...Read moreng to restore proper function and extend the life of your tool. Made from durable metal, this part is built to withstand heavy use and is sold individually. For correct placement and compatibility, please refer to your tool’s model diagram before installation.