Models > DSKS433ET0 > Instructions

DSKS433ET0 General Electric Dryer - Instructions

All Instructions for the DSKS433ET0
61 - 66 of 66
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Door would not close
Removed door strike and latch, replaced, works like new.
Parts Used:
Door Latch Door Strike
  • Arlie from Ringoes, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
Was this instruction helpful to you?
Thank you for voting!
dryer continue spining when door is even open.
the switch was stuck couldn't get the switch to pop out to stop the dryer when opening the door light inside also wouldnt go on. it only took a few min to take it the switch and replace the new switch the light now works also stops when opening the door it made my day easierhow easy it was to fix it. only take to use a pliers and screw driver.
Parts Used:
Door Switch
  • Kevin from San Dimas, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
dryer did not latch
easy to fix took less than 10 minutes
Parts Used:
Door Strike
  • janet from martinsville, IN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Dryer door would no longer shut.
Simply popped the old broken part out and popped the new part into place. I wasn't sure if it was the Latch Door or the Door Strike. Once the parts arrived, it was clear the Door Strike was not the issue.
Parts Used:
Door Latch
  • Fawn from Loganville, GA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Door switch failed
Make sure your power is off, When loosened the top and tilted back, the first thing I saw was the door switch, I guess I was just lucky I disconnected the two wires and checked it and it was bad. Got my new one from you and installed it. It has a ground terminal, which my model switch only had the two terminals. It working fine.I took the bad switch apart and the one leg on the copper U shaped contact had broken off. The Belt I have as a spare.
Parts Used:
Door Switch
  • William from Medford, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
dryer door would not stay closed
inserted the latch into the opening in the front face of the dryer
Parts Used:
Door Latch
  • Dave from Redondo Beach, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the DSKS433ET0
61 - 66 of 66
Back to Top