DGHX2655TF6 Frigidaire Refrigerator - Instructions

Well, after watching the video before ordering the part, I ordered the correct part. My wife had ordered the wrong part that I had to return and ordered the correct one. To install the glass you just take out the crisper above shelf and lay the glass in place. So simple.

slide in new draw

Nothing exciting - just replaced the defective drawer covers with the new parts. The guides are poorly designed. the bottom guides on both covers failed.

Took out old drawer. Removed clips from that drawer in rear and clipped onto new. Removed humidifier control from old and inserted into new. Slid drawer onto track.

Undo a few bolts unplug power and unhook water lines then recut all lines and push in to new value

Straight forward repair. Remove the four screws holding cardboard back. Remove the 2 screws holding the valve. Unscrew the water lines and unplug the electrical connections. I would caution that it would be wise to either take a couple photos or write down the order of connection. Even though it is somewhat color coded and the water lines are different sizes, a photo removes any confusion. My old valve had threaded connections using brass nuts and ferrules. The new valve has push in connections so you need to cut the ferrules off.. When cutting off the tubing, be sure to cut square. An angled or "squished" cut will leak when pushed into the fitting. Attach the valve to the refrigerator with 2 screws and replace the cardboard back and you're finished. While you have the back off is a good time to clean the coils. I left my fridge out and back off for a couple of ice making cycles so I could check for leaks (how I know the tubing needs to be cut very square). All in all, a very easy fix.

Took the glass out of the shipping box and it just slid right in. It was a perfect match.

Removed exterior housing, sliding old unit forward to release. New unit went in easily. Caution wires don't get pinched.

needed replacements parts.

The repair didn't happen. The bin arrived broken and I have been ignored by whoever takes care of getting me a replacement. I would very much appreciate some communication

Tried JB Weld, not sufficient.

Got online, looked at the parts fiche for my model, chose the crisper top frame. Wrong part. Sent it back (shipping as $60 on a $125 part).
Ordered the part that the wheel appears to be screwed into (described as crisper support frame. Ordered new $11 plastic wheel as well.

Wrong part. It appears that the crisper drawers on my unit are supported by a monolithic piece (solid plastic) that includes the frame as well as the locators for the wheels. I could send pictures, but have decided to abandon fixing it. (I tossed the metal support that was the second order into the trash ($60 part)....

carefully removed retainer from old valve

The u tube instructions were exactly what is needed. I had to cut off the old plastic pipes. My pipe had threaded connectors. Pex push on connection is super easy. You don't really need a block of wood to cut it if you have a sharp utility blade. If if you are sure this is the problem this is a really easy fix. Steps 1 turn off water at wall unplug electric also 2. Disc line at valve on refrigerator 3. Remove 2 screws holding valve 4. Pull valve out and remove plastic hoses and electric connections pay attention to color of pipe and electric connection. Mine were color coded. Had to cut off thread connectors. Reattach in reverse order or do one at a time. Check for leaks.

Write down where tubing goes, wiring is color coded.

The part was easy to install and solved the problem! We had ice within hours. Thanks PartSelect!