DGHF2360PFAA Frigidaire Refrigerator - Parts

This manufacturer-approved air filter system for refrigerators eliminates odors and any impurities. It does this by neutralizing and removing odor-causing molecules. For best results, it is important to change the filter every 6 months to ensure that food is kept fresh, and the humidity is controlled. This part measures about 7 inches wid...Read moree and 5 inches deep. Follow installation instructions provided by the manufacturer when installing this part to ensure accurate results and further guidance. Remember to unplug the refrigerator from the power source before starting this project. The air filter may be located in different places depending on your appliance, but is usually on the inner right or left side. See your manual for exact location. Our customers rated this as a very easy repair that takes only a few minutes; just locate and remove the old air filter and insert the new one to complete the repair, which requires no tools.

This genuine PureSource Ultra water filter will fit most Frigidaire french door and side by side refrigerators. You will find this filter located in the back, top right of the appliance. It is white in color and the filter has a polypropylene plastic housing and extruded carbon block filter media. Certified by NSF/ANSI to reduce contamina...Read morents that may be in your household water supply by 99.8 percent. The operating temperature for this filter is 33-100 degrees Fahrenheit, the flow rate is 0.5 GPM, the working pressure is 30-100 PSI, and it has a micron rating of 1. This filter should be replaced every six months or when the indicator lights up red. Installation is quick and easy. Push on the end face of the older filter to allow it to release. Remove and discard the old filter. Slide the new filter into the housing and press it down until it locks into place. Be sure to run water through the dispenser for about three minutes to prime the filter before use. Discard this water or use it to water plants. Do not forget to reset the indicator by pressing it down for 3-10 seconds. Review the use and care guide before you install for more detailed instructions.

This GREY magnetic door gasket is designed to help your 36-inch French-door refrigerator maintain a consistent internal temperature by forming a tight seal between the doors and the cabinet. Made from durable white material, it keeps cold air in and warm air out—helping preserve food freshness and reduce energy consumption. If your curren...Read moret gasket is worn, cracked, or no longer sealing properly, replacing it can improve your refrigerator’s performance and efficiency. This replacement part is compatible with select models and installs easily.

Keep your produce fresh and your fridge organized with this crisper drawer cover. It fits over the crisper bins and includes a glass shelf and built-in brackets so the drawer slides easily. Made for Frigidaire and other compatible brands like Kenmore and Tappan, it helps control humidity and adds extra shelf space. No tools needed—just slide it into place.

This is a genuine Frigidaire part for your refrigerator. This is an ice maker, which connects to the water lines to provide fresh ice. The most common reason to replace this part is if your refrigerator is leaking, or it will not produce ice cubes. Be sure to disconnect the power to your refrigerator before beginning this repair.

This replacement crisper pan roller helps your refrigerator drawer glide smoothly in and out, making it easy to access stored items. Made from durable plastic, the roller attaches to the sides of the crisper pan and supports stable movement. If the drawer feels loose, unstable, or difficult to slide, the roller may be worn, broken, or mis...Read moresing. Each roller is sold individually, so be sure to order the correct quantity for your refrigerator model. For best results, refer to your appliance’s manual during installation.

Ensure your freezer operates efficiently with this replacement drawer gasket, designed to form a tight seal that keeps cold air in and warm air out. Made in light gray and compatible with select models, it helps maintain proper temperature control and reduce energy consumption. Replace the gasket if you notice signs of wear such as cracki...Read moreng, loss of elasticity, or frost buildup inside the freezer. This part is sold individually.

This mullion hinge pin is designed to secure the mullion in place within compatible refrigerator models, allowing it to pivot smoothly as the doors open and close. Measuring approximately 1.5 inches by 1.25 inches by 0.85 inches, it helps maintain proper separation between the refrigerator and freezer compartments, supporting consistent i...Read morenternal temperatures. A damaged or loose hinge pin can lead to temperature fluctuations, frost buildup, and difficulty operating the doors. Replacement involves removing the mullion cover, detaching the old pin, inserting the new one into the hinge assembly, and reattaching the cover. Some models may require two pins—one at the top and one at the bottom. Each pin is sold individually.

Sold Individually.

This is the replacement water filter base for your refrigerator. It is approximately 3-1/2 inches by 3 inches. It is made of white plastic with two blue water filter receptacles. The water filter base connects to your refrigerator and is the part that your two-headed water filter fits into. The main reason you would want to replace it is ...Read moreif you notice a leak when you connect the water filter, or if it is noticeably cracked or damaged. This part is sold individually and is a genuine OEM part.

The water inlet valve supplies water to the refrigerator ice maker and water dispenser. This part works with the following brands: Frigidaire, White Westinghouse, Kelvinator, Gibson, Kenmore, Sears, Tappan, & Electrolux. Possible Repair Solution For: Leaking water, water will not dispense, ice maker does not make ice, ice maker doe...Read mores not dispense ice. This is an authentic water inlet valve (4 coil), which works with refrigerators.

This genuine OEM hinge mounting screw is designed for use in Frigidaire and Electrolux refrigerators, providing a secure and reliable way to fasten door hinges to the cabinet. Built with a durable hex washer head and standard threading, it helps restore proper door alignment and maintain a tight seal to prevent cold air loss. Ideal for re...Read moreplacing worn, stripped, or corroded hardware, this heavy-duty screw ensures long-lasting stability and dependable everyday performance.